The hexavalent chromium (Cr(VI)) removal capacity of acid-washed zerovalent iron (AW-Fe0) was evaluated under different groundwater geochemistry conditions through column experiments. It was found that each gram of the AW-Fe0 could remove 0.65-1.76 mg of Cr(VI) from synthetic groundwater in the absence of bicarbonate (HCO3-), magnesium and/or calcium ions. Groundwater geochemistry was found to exert various degrees of impact on Cr(VI) removal by the AW-Fe0, in which HCO3- alone gave the mildest impact whereas the copresence of calcium and HCO3- exerted the greatest impact In comparison with the unwashed Fe0, the AW-Fe0 showed a poorer Cr(VI) removal capacity and was also more susceptible to the influence of the dissolved groundwater constituents on Cr(VI) removal,thereby indicating the unsuitability of using AW-Fe0 in permeable reactive barriers for remediation of Cr(VI)-contaminated groundwater. On the AW-Fe0 surface, where the indigenous iron precipitates were almost erased, trivalent chromium including chromium (III) oxides, hydroxides, and oxyhydroxides in irregular strip, chick footmark-liked or boulder-liked forms as well as Cr(III)-Cr(VI) mixed oxides were detected.
The salinity levels of wastewater and sludge are relatively high in some coastal cities as they may use saline water for toilet flushing, and as such,the sludge dewaterability can be affected by it. The salinity effect on sludge dewaterability was therefore investigated through experimental testing of specific resistance in filtration (SRF), time to filter (TTF), and final solid content of sludge. SRF and TTF were determined using Buchner funnel tests. The final solid content was estimated by centrifuging the sludge at four levels of rotational speed. Sludge with three salinity levels (5,000, 10,000 and 20,000 ppm) were considered in this study. Coagulants such as alum, iron(II) sulfate, and organic polyelectrolytes were added to the sludgetostudythe dewaterability of such sludge with chemical conditioning. Experimental results show that doubling the salinity level of the sludge from 10,000 to 20,000 ppm shows not much change in SRF and TTF. Compared with the sludge without chemical conditioning, the addition of the coagulants to the sludge at a salinity level of 5,000 ppm drastically reduces its SRF and TTF. However, sludge with and without chemical conditioning at a salinity of 20,000 ppm has similar SRF and TTF. The final solid content of sludge increases almost linearly with salinity. Among the coagulants used in this study, the cationic polyelectrolyte is found to be better in improving sludge dewaterability, while iron(II) sulfate performs slightly better in enhancing the final solid content of the sludge.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.