Large magnetic-field-induced strains have been observed in Heusler alloys with a body-centred cubic ordered structure and have been explained by the rearrangement of martensite structural variants due to an external magnetic field. These materials have attracted considerable attention as potential magnetic actuator materials. Here we report the magnetic-field-induced shape recovery of a compressively deformed NiCoMnIn alloy. Stresses of over 100 MPa are generated in the material on the application of a magnetic field of 70 kOe; such stress levels are approximately 50 times larger than that generated in a previous ferromagnetic shape-memory alloy. We observed 3 per cent deformation and almost full recovery of the original shape of the alloy. We attribute this deformation behaviour to a reverse transformation from the antiferromagnetic (or paramagnetic) martensitic to the ferromagnetic parent phase at 298 K in the Ni45Co5Mn36.7In13.3 single crystal.

Martensitic and magnetic transformations of the Heusler Ni50Mn50−yXy (X=In, Sn and Sb) alloys were investigated by differential scanning calorimetry measurement and the vibrating sample magnetometry technique. In all these alloy systems, the austenite phase with the ferromagnetic state was transformed into the martensite phase, which means that these Heusler alloys have potential as Ga-free ferromagnetic shape memory alloys (FSMAs). Furthermore, multiple martensitic transformations, such as two- or three-step martensitic transformations, occur in all these alloy systems. It was confirmed by transmission electron microscopy observation that the crystal structure of the martensite phase is an orthorhombic four-layered structure which has not been reported in other FSMAs. Therefore, the present Ga-free FSMAs have the great possibility of the appearance of a large magnetic-field-induced strain.

We have identified cobalt-base superalloys showing a high-temperature strength greater than those of conventional nickel-base superalloys. The cobalt-base alloys are strengthened by a ternary compound with the L1(2) structure, gamma' Co3(Al,W), which precipitates in the disordered gamma face-centered cubic cobalt matrix with high coherency and with high melting points. We also identified a ternary compound, gamma' Ir3(Al,W), with the L1(2) structure, which suggests that the Co-Ir-Al-W-base systems with gamma+gamma' (Co,Ir)3(Al,W) structures offer great promise as candidates for next-generation high-temperature materials.

Shape-memory alloys, such as Ni-Ti and Cu-Zn-Al, show a large reversible strain of more than several percent due to superelasticity. In particular, the Ni-Ti-based alloy, which exhibits some ductility and excellent superelastic strain, is the only superelastic material available for practical applications at present. We herein describe a ferrous polycrystalline, high-strength, shape-memory alloy exhibiting a superelastic strain of more than 13%, with a tensile strength above 1 gigapascal, which is almost twice the maximum superelastic strain obtained in the Ni-Ti alloys. Furthermore, this ferrous alloy has a very large damping capacity and exhibits a large reversible change in magnetization during loading and unloading. This ferrous shape-memory alloy has great potential as a high-damping and sensor material.

In superelastic alloys, large deformation can revert to a memorized shape after removing the stress. However, the stress increases with increasing temperature, which limits the practical use over a wide temperature range. Polycrystalline Fe-Mn-Al-Ni shape memory alloys show a small temperature dependence of the superelastic stress because of a small transformation entropy change brought about by a magnetic contribution to the Gibbs energies. For one alloy composition, the superelastic stress varies by 0.53 megapascal/°C over a temperature range from -196 to 240°C.

A system of ferromagnetic β phase Ni–Co–Al alloys with an ordered B2 structure that exhibits the shape memory effect has been developed. The alloys of this system within the composition range Ni (30–45 at. %) Co–(27–32 at. %) Al, undergo a paramagnetic/ferromagnetic transition as well as a thermoelastic martensitic transformation from the β to the β′(L10) phase. The Curie and the martensitic start temperatures in the β phase can be controlled independently to fall within the range of 120–420 K. The specimens from some of the alloys undergoing martensitic transformation from ferromagnetic β phase to ferromagnetic β′ phase are accompanied by the shape memory effect. These ferromagnetic shape memory alloys hold great promise as new smart materials.

Ferromagnetic shape memory alloys with a body-centered-cubic ordered structure in a Ni–Ga–Fe system have been developed. The alloys with the composition range of Ni 27 at. % Ga (20–22 at. %)Fe exhibit a thermoelastic martensitic transformation from a B2 and/or an L21 parent to a martensite phase, with a seven-layer modulated (14M) and a five-layer modulated (10M) structure, in the ferromagnetic state. The parent phase transforms from the B2 to the L21 structure at about 970 K during cooling, and the degree of the L21 order in the parent phase is increased by annealing at 773 K, resulting in the increase of both the martensite starting and the Curie temperatures. The ductility of these alloys is improved by introducing of a small amount of a γ-phase solid solution. Consequently, we can conclude that the present alloys are promising for ferromagnetic shape memory alloys.

No abstract