There are numerous examples of fault-controlled, so-called hydrothermal dolomite (HTD), many of which host economic mineral deposits or hydrocarbons, but there remains a lack of consensus as to how they form. In particular, multiple phases of diagenetic overprinting can obscure geochemical fingerprints. Study of a Cenozoic succession with a relatively simple burial history here provides new insights into the development of differentially dolomitized beds. The Hammam Faraun fault (HFF) block within the Suez Rift, Egypt, hosts both massive and stratabound dolostone bodies. Non-fabric-selective massive dolostone is limited to the damage zone of the fault, while fabric-selective stratabound dolostone bodies penetrate nearly 2 km into the footwall. Oligo-Miocene seawater is interpreted to have been drawn down discrete faults into a deep aquifer and convected upwards along the HFF. Escape of fluids from the incipient HFF into the lower Thebes Formation led to differential, stratabound dolomitization. Once the HFF breached the surface, fluid circulation focused along the fault plane to form younger, massive dolostone bodies. This study provides a snapshot of dolomitization during the earliest phases of extension, unobscured by subsequent recrystallization and geochemical modification. Contrary to many models, stratabound dolomitization preceded non-stratabound dolomitization. Fluids were hydrothermal, but with little evidence for rapid cooling and brecciation common to many HTD bodies. These results suggest that many of the features used to interpret and predict the geometry of HTD in the subsurface form during later phases of structural deformation, perhaps overprinting less structurally complex dolomite bodies.

There are numerous examples of fault-controlled, so-called hydrothermal dolomite (HTD), many of which host economic mineral deposits or hydrocarbons, but there remains a lack of consensus as to how they form. In particular, multiple phases of diagenetic overprinting can obscure geochemical fingerprints. Study of a Cenozoic succession with a relatively simple burial history here provides new insights into the development of differentially dolomitized beds. The Hammam Faraun fault (HFF) block within the Suez Rift, Egypt, hosts both massive and stratabound dolostone bodies. Non-fabric-selective massive dolostone is limited to the damage zone of the fault, while fabric-selective stratabound dolostone bodies penetrate nearly 2 km into the footwall. Oligo-Miocene seawater is interpreted to have been drawn down discrete faults into a deep aquifer and convected upwards along the HFF. Escape of fluids from the incipient HFF into the lower Thebes Formation led to differential, stratabound dolomitization. Once the HFF breached the surface, fluid circulation focused along the fault plane to form younger, massive dolostone bodies. This study provides a snapshot of dolomitization during the earliest phases of extension, unobscured by subsequent recrystallization and geochemical modification. Contrary to many models, stratabound dolomitization preceded non-stratabound dolomitization. Fluids were hydrothermal, but with little evidence for rapid cooling and brecciation common to many HTD bodies. These results suggest that many of the features used to interpret and predict the geometry of HTD in the subsurface form during later phases of structural deformation, perhaps overprinting less structurally complex dolomite bodies.

Fault-controlled dolostone bodies have been described as potential hydrocarbonbearing reservoirs. Numerous case studies have described the shape and size of these often non fabric selective dolostone bodies within the vicinity of crustal-scale lineaments, usually from Palaeozoic or Mesozoic carbonate platforms, which have undergone one or more phases of burial and exhumation. There has been little attention paid, however, to fault-strike variability in dolostone distribution or the preferential localization of these bodies on particular faults. This study focuses on dolostone bodies adjacent to the Hammam Faraun Fault (HFF), Gulf of Suez. This crustalscale normal fault was activated in the Late Oligocene, coincident with the onset of extension within the Suez Rift. Dolomitization in the prerift Eocene Thebes Formation occurred in the immediate footwall of the HFF forming two massive, non facies selective dolostone bodies, ca. 500 m wide. Facies-controlled tongues of dolostone on the margins of the massive dolostone bodies extend for up to 100 m. The geochemical signature of the dolostone bodies is consistent with replacement by Miocene seawater, contemporaneous with the rift climax and localization of strain along the HFF. A conceptual model of dolomitization from seawater that circulated within the HFF during the rift climax is presented. Seawater was either directly drawn down the HFF or circulated from the hanging wall basin via a permeable aquifer towards the HFF. The lateral extent of the massive dolostone bodies was controlled by pre-existing HFF-parallel fracture corridors on the outer margins of the damage zone of the fault. The behaviour of these fracture corridors alternated between acting as barriers to fluid flow before rupture and acting as flow conduits during or after rupture. Multiple phases of dolomitization and recrystallization during the ca.10 Ma period in which dolomitization occurred led to mottled petrographical textures and wide-ranging isotopic signatures. The localization of dolomitization on the HFF is interpreted to reflect its proximity to a rift accommodation zone which facilitated vertical fluid flow due to perturbed and enhanced stresses during fault interaction. It is possible that the presence of jogs along the strike of the fault further focused fluid flux. As such, it is suggested that the massive dolostones described in --

Dolomitization is commonly associated with crustal‐scale faults, but tectonic rejuvenation, diagenetic overprinting and a fluid and Mg mass‐imbalance often makes it difficult to determine the dolomitization mechanism. This study considers differential dolomitization of the Eocene Thebes Formation on the Hammam Faraun Fault block, Gulf of Suez, which has undergone a simple history of burial and exhumation as a result of rifting. Stratabound dolostone bodies occur selectively within remobilized sediments (debrites and turbidites) in the lower Thebes Formation and extend into the footwall of, and for up to 2 km away from, the Hammam Faraun Fault. They are offset by the north–south trending Gebel fault, which was active during the earliest phases of rifting, suggesting that dolomitization occurred between rift initiation (26 Ma) and rift climax (15 Ma). Geochemical data suggest that dolomitization occurred from evaporated (ca 1·43 concentration) seawater at less than ca 80°C. Geothermal convection is interpreted to have occurred as seawater was drawn down surface‐breaching faults into the Nubian sandstone aquifer, convected and discharged into the lower Thebes Formation via the Hammam Faraun Fault. Assuming a ca 10 Myr window for dolomitization, a horizontal velocity of ca 0·7 m year−1 into the Thebes Formation is calculated, with fluid flux and reactivity likely to have been facilitated by fracturing. Although fluids were at least marginally hydrothermal, stratabound dolostone bodies do not contain saddle dolomite and there is no evidence of hydrobrecciation. This highlights how misleading dolostone textures can be as a proxy for the genesis and spatial distribution of such bodies in the subsurface. Overall, this study provides an excellent example of how fluid flux may occur during the earliest phases of rifting, and the importance of crustal‐scale faults on fluid flow from the onset of their growth. Furthermore, this article presents a mechanism for dolomitization from seawater that has none of the inherent mass balance problems of classical, conceptual models of hydrothermal dolomitization.

Petrographic and petrophysical data from different limestone lithofacies (skeletal packstones, matrix-supported conglomerates and foraminiferal grainstones) and their dolomitized equivalents within a slope carbonate succession (Eocene Thebes Formation) of Hammam Faraun Fault Block (Suez Rift, Egypt) have been analyzed in order to link fracture distribution with mechanical and textural properties of these rocks. Two phases of dolomitization resulted in facies-selective stratabound dolostones extending up to two and a half kilometers from the Hammam Faraun Fault, and massive dolostones in the vicinity of the fault (100 metres). Stratabound dolostones are characterized by up to 8 times lower porosity and 6 times higher frequency of fractures compared to the host limestones. Precursor lithofacies type has no significant effect on fracture frequency in the stratabound dolostones. At a distance of 100 metres from the fault, massive dolostones are present which have 0.5 times porosity of precursor limestones, and lithofacies type exerts a stronger control on fracture frequency than the presence of dolomitization (undolomitized vs. dolomitized). Massive dolomitization corresponds to increased fracture intensity in conglomerates and grainstones but decreased fracture intensity in packstones. This corresponds to a decrease of grain/crystal size in conglomerates and grainstones and its increase in packstones after massive dolomitization. Since fractures may contribute significantly to the flow properties of a carbonate rock, the work presented herein has significant applicability to hydrocarbon exploration and production from limestone and dolostone reservoirs, particularly where matrix porosities are low.