No abstract

No abstract

The work is focused on evaluation of resistance of the welded joint made of supermartensitic 13Cr6Ni2.5Mo stainless steel to sulfide stress cracking. Testing method A and solution B in accordance with NACE TM 0177 were used. All the testing samples were ruptured in a very short time interval but welded joint samples were fractured primarily in the weld metal or in heat affected zone and not in the basic material. Material analysis of samples were made with use of a ZEISS NEOPHOT 32 light microscope and a JEOL 6490LV scanning electron microscope.

Based on dilatometric tests, the effect of various values of previous deformation on the kinetics of austenite transformations during the cooling of 100Cr6 steel has been studied. Dilatometric tests have been performed with the use of the optical dilatometric module of the plastometer Gleeble 3800. The obtained results were compared to metallographic analyses and hardness measurements HV30. Uniaxial compression deformations were chosen as follows: 0, 0.35, and 1; note that these are true (logarithmic) deformations. The highly important finding was the absence of bainite. In addition, it has been verified that with the increasing amount of deformation, there is a further shift in the pearlitic region to higher cooling rates. The previous deformation also affected the temperature martensite start, which decreased due to deformation. The deformation value of 1 also shifted the critical cooling rate required for martensite formation from the 12 °C/s to 25 °C/s.

No abstract