Reported are complexes of the formula Fe(dithiolate)(CO)2(diphos) and their use to prepare homo- and heterobimetallic dithiolato derivatives. The starting iron dithiolates were prepared by a one-pot reaction of FeCl2 and CO with chelating diphosphines and dithiolates, where dithiolate = S2(CH2)22– (edt2–), S2(CH2)32– (pdt2–), S2(CH2)2(C(CH3)2)2– (Me2pdt2–) and diphos = cis-C2H2(PPh2)2 (dppv), C2H4(PPh2)2 (dppe), C6H4(PPh2)2 (dppbz), C2H4[P(C6H11)2]2 (dcpe). The incorporation of 57Fe into such building block complexes commenced with the conversion of 57Fe into 57Fe2I4(iPrOH)4, which then was treated with K2pdt, CO, and dppe to give 57Fe(pdt)(CO)2(dppe). NMR and IR analyses show that these complexes exist as mixtures of all-cis and trans-CO isomers, edt2– favoring the former and pdt2– the latter. Treatment of Fe(dithiolate)(CO)2(diphos) with the Fe(0) reagent (benzylideneacetone)Fe(CO)3 gave Fe2(dithiolate)(CO)4(diphos), thereby defining a route from simple ferrous salts to models for hydrogenase active sites. Extending the building block route to heterobimetallic complexes, treatment of Fe(pdt)(CO)2(dppe) with [(acenaphthene)Mn(CO)3]+ gave [(CO)3Mn(pdt)Fe(CO)2(dppe)]+ ([3d(CO)]+). Reduction of [3d(CO)]+ with BH4– gave the Cs-symmetric μ-hydride (CO)3Mn(pdt)(H)Fe(CO)(dppe) (H3d). Complex H3d is reversibly protonated by strong acids, the proposed site of protonation being sulfur. Treatment of Fe(dithiolate)(CO)2(diphos) with CpCoI2(CO) followed by reduction by Cp2Co affords CpCo(dithiolate)Fe(CO)(diphos) (4), which can also be prepared from Fe(dithiolate)(CO)2(diphos) and CpCo(CO)2. Like the electronically related (CO)3Fe(pdt)Fe(CO)(diphos), these complexes undergo protonation to afford the μ-hydrido complexes [CpCo(dithiolate)HFe(CO)(diphos)]+. Low-temperature NMR studies indicate that Co is the kinetic site of protonation.
Active site mimics of [FeFe]-hydrogenase are shown to be bidirectional catalysts, producing H2 upon treatment with protons and reducing equivalents. This reactivity complements the previously reported oxidation of H2 by these same catalysts in the presence of oxidants. The complex Fe2(adtBn)(CO)3(dppv)(PFc*Et2) ([1]0; adtBn = (SCH2)2NBn, dppv = cis-1,2-bis(diphenylphosphino)ethylene, PFc*Et2 = Et2PCH2C5Me4FeCp*) reacts with excess [H(OEt2)2]BArF4 (BArF4– = B(C6H3-3,5-(CF3)2)4–) to give ∼0.5 equiv of H2 and [Fe2(adtBnH)(CO)3(dppv)(PFc*Et2)]2+ ([1H]2+). The species [1H]2+ consists of a ferrocenium ligand, an N-protonated amine, and an FeIFeI core. In the presence of additional reducing equivalents in the form of decamethylferrocene (Fc*), hydrogen evolution is catalytic, albeit slow. The related catalyst Fe2(adtBn)(CO)3(dppv)(PMe3) (3) behaves similarly in the presence of Fc*, except that in the absence of excess reducing agent it converts to the catalytically inactive μ-hydride derivative [μ-H3]+. Replacement of the adt in [1]0 with propanedithiolate (pdt) results in a catalytically inactive complex. In the course of synthesizing [FeFe]-hydrogenase mimics, new routes to ferrocenylphosphine ligands and nonamethylferrocene were developed.
We report a biobased route to methacrylic acid via selective decarboxylation of itaconic acid utilizing catalytic ruthenium carbonyl propionate in an aqueous solvent system. High selectivity (>90%) was achieved at low catalyst loading (0.1 mol %) with high substrate concentration (5.5 M) at low temperature (200−225 °C) and pressure (≤425 psig) relative to previous contributions in this area. Direct decarboxylation of itaconic acid was achieved as opposed to the conjugate base reported previously, thereby avoiding basification and acidification steps. Also investigated was catalytic manganese(II) oxalate (5 mol %), but low yield (4.8%) and evolution of carbon monoxide via oxalate decomposition was problematic. Attempts at stabilization of the catalyst with triphenylphosphine were unsuccessful, but it exhibited greater catalytic efficacy (14.0% yield) than the manganese catalyst (4.8% yield) at 5 mol %. Neither carbon monoxide nor propylene (excessive decarboxylation) were detected during ruthenium-catalyzed decarboxylation. In addition, cosolvents such as tetraglyme lowered vapor pressures within the reaction vessel by >100 psig while minimizing decomposition of starting acids. In combination, these findings represent improvements over existing methodologies that may facilitate sustainable production of methacrylic acid, an important petrochemically based monomer for the plastics industry.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.