No abstract

No abstract

We have proposed and investigated a model of drying colloidal suspension drop placed onto a horizontal substrate in which the sol to gel phase transition occurs. The temporal evolution of volume fraction of the solute and the gel phase dynamics were obtained from numerical simulations. Our model takes into account the fact that some physical quantities are dependent on volume fraction of the colloidal particles.

Four samples of transparent conductive films with different numbers of silver nanorings per unit area were produced. The sheet resistance, transparency, and haze were measured for each sample. Using Monte Carlo simulation, we studied the electrical conductivity of random resistor networks produced by the random deposition of the conducting rings onto the substrate. Both systems of equal-sized rings, and systems with rings of different sizes were simulated. Our simulations demonstrated the linear dependence of the electrical conductivity on the number of rings per unit area. Size dispersity decreased the percolation threshold, but without having any other significant effect on the behavior of the electrical conductance. Analytical estimations obtained for dense systems of equal-sized conductive rings were consistent with the simulations.

The electrical conductivity of two-dimensional films filled with rodlike particles (rods) was simulated by the Monte Carlo method. The main attention has been paid to the investigation of the effect of the rod alignment on the electrical properties of the films. Both continuous and lattice approaches were used. Intersections of particles were forbidden. Our main findings are (i) both models demonstrate similar behaviors, (ii) at low concentration of rods, both approaches lead to the same dependencies of the electrical conductivity on the concentration of the rods, (iii) the alignment of the rods essentially affects the electrical conductivity, (iv) at some concentrations of partially aligned rods, the films may be conducting only in one direction, and (v) the films may simultaneously be both highly transparent and electrically anisotropic.