Ejected material from neutron star mergers give rise to electromagnetic emission powered by radioactive decays of r-process nuclei, which is so called kilonova or macronova. While properties of the emission are largely affected by opacities in the ejected material, available atomic data for r-process elements are still limited. We perform atomic structure calculations for r-process elements: Se (Z = 34), Ru (Z = 44), Te (Z = 52), Ba (Z = 56), Nd (Z = 60), and Er (Z = 68). We confirm that the opacities from bound-bound transitions of open f-shell, Lanthanide elements (Nd and Er) are higher than those of the other elements over a wide wavelength range. The opacities of open s-shell (Ba), p-shell (Se and Te), and d-shell (Ru) elements are lower than those of open f-shell elements and their transitions are concentrated in the ultraviolet wavelengths. We show that the optical brightness can be different by > 2 mag depending on the element abundances in the ejecta such that post-merger, Lanthanide-free ejecta produce brighter and bluer optical emission. Such blue emission from post-merger ejecta can be observed from the polar directions if the mass of the preceding dynamical ejecta in these regions is small. For the ejecta mass of 0.01 M ⊙ , observed magnitudes of the blue emission will reach 21.0 mag (100 Mpc) and 22.5 mag (200 Mpc) in g and r bands within a few days after the merger, which are detectable with 1m or 2m-class telescopes.

Abstract:We have measured extreme ultraviolet (EUV)

Self-organization of a two-dimensional array of nanoholes which were formed by anodic oxidation of aluminum was investigated quantitatively using fast Fourier transformation (FFT) analysis of scanning electron microscopy (SEM) images. The highly ordered array of nanoholes with diameters of 26 nm was obtained by two-step anodization at anodic voltage around 40 V, and oxalic acid concentration of 0.5 M. A two-dimensional ordered array of Au free standing nanowires was successfully fabricated by the deposition of Au using DC electroplating in nanoholes of aluminum oxide, by removal of the aluminum oxide barrier layer using wet chemical etching. The present method has a high efficiency to fabricate ordered nanowire array of a variety of conductive materials in a large area, and wide applications for fabricating quantum effect devices and materials would be expected.

KLL dielectronic recombination resonances, where a free electron is captured into the L shell and at the same time a K shell electron is excited into the L shell, have been measured for open shell iodine ions by measuring the detected yield of escaping ions of various charge states and modeling the charge balance in an electron beam ion trap. In the modeling, the escape from the trap and multiple charge exchange were considered. Extracted ions were used to measure the charge balance in the trap. The different charge states were clearly separated, which along with the correction for artifacts connected with ion escape and multiple charge exchange made the open shell highly charged ion measurements of this type possible for the first time. From the measured spectra resonant strengths were obtained. The results were 4.27͑39͒ ϫ