Perovskite light-emitting diodes (PeLEDs), because of its fundamental scientific importance and practical applications in the fields of low-cost light source or display applications, have drawn worldwide attention in recent years. However, PeLEDs available today suffer from a compromise in their emission efficiency and operation stability. In this study, we designed and fabricated a stacking all-inorganic multilayer structure by using inorganic perovskite CsPbBr quantum dots (QDs) as the emissive layer and inorganic n-type MgZnO and p-type MgNiO as the carrier injectors, respectively. Through energy band engineering of carrier injectors by Mg incorporation and their thickness optimization, PeLEDs with maximum luminance of 3809 cd/m, luminous efficiency of 2.25 cd/A, and external quantum efficiency of 2.39% have been realized, which are much better than most PeLEDs from CHNHPbBr films, and comparable with the highest results reported on CsPbBr QDs LEDs. More importantly, the unencapsulated PeLEDs in a continuous current mode demonstrate a remarkable operation stability against water and oxygen degradation. After a continuous operation for 10 h under a dc bias (10.0 V), nearly 80% of the original efficiency of the PeLEDs has been retained, greatly superior to reference and other previously reported devices constructed with conventional organic carrier injectors. Our results obtained open possibilities for the design and development of high-efficiency and air-stable PeLEDs that are not dependent on expensive and less-stable organic carrier injectors.
Recently, a pressing requirement of solid-state lighting sources with high performance and low cost has motivated increasing research in metal halide perovskites. However, the relatively low emission efficiency and poor operation stability of perovskite light-emitting diodes (LEDs) are still critical drawbacks. In this study, a strategy of solution-processed all-inorganic heterostructure was proposed to overcome the emission efficiency and operation stability issues facing the challenges of perovskite LEDs. Solution-processed n-ZnO nanoparticles and p-NiO are used as the carrier injectors to fabricate all-inorganic heterostructured CsPbBr quantum dot LEDs, and a high-efficiency green emission is achieved with maximum luminance of 6093.2 cd/m, external quantum efficiency of 3.79%, and current efficiency of 7.96 cd/A. More importantly, the studied perovskite LEDs possess a good operation stability after a long test time in air ambient. Typically, the devices can endure a high humidity (75%, 12 h) and a high working temperature (393 K, three heating/cooling cycles) even without encapsulation, and the operation stability is better than any previous reports. It is anticipated that this work will provide an effective strategy for the fabrication of high-performance perovskite LEDs with good stability under ambient and harsh conditions, making practical applications of such LEDs a real possibility.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.