BackgroundSquatting is a core exercise for many purposes. The tissue loading during squatting is crucial for positive adaptation and to avoid injury. This study aimed to evaluate the effect of narrow, hip and wide stance widths, foot position angles (0°, 21°, and 42°), strength exercise experience, and barbell load (0 and 50% body weight, experts only) during squatting.MethodsNovice (N = 21) and experienced (N = 21) squatters performed 9 different variations of squats (3 stance widths, 3 foot placement angles). A 3D motion capture system (100 Hz) and two force plates (2000 Hz) were used to record mediolateral knee displacement (ΔD*), range of motion (RoM) at the hip and knee joints, and joint moments at the hip, knee, and lower back.ResultsBoth stance width and foot placement angles affected the moments at the hip and knee joints in the frontal and sagittal planes. ΔD* varied with stance width, foot placement angles and between the subjects’ level of experience with the squat exercise as follows: increasing foot angle led to an increased foot angle led to an increased ΔD*, while an increased stance width resulted in a decreased ΔD*; novice squatters showed a higher ΔD*, while additional weight triggered a decreased ΔD*.ConclusionsSuitable stance width and foot placement angles should be chosen according to the targeted joint moments. In order to avoid injury, special care should be taken in extreme positions (narrow stand-42° and wide stance-0°) where large knee and hips joint moments were observed.Electronic supplementary materialThe online version of this article (10.1186/s13102-018-0103-7) contains supplementary material, which is available to authorized users.

Injuries to the shoulder are very common in sports that involve overhead arm or throwing movements. Strength training of the chest muscles has the potential to protect the shoulder from injury. Kinematic and kinetic data were acquired in 20 healthy subjects (age: 24.9 ± 2.7 years) using motion capture, force plates for the bench press exercises and load cells in the cable for the cable pulley exercises with 15% and 30% of body weight (BW). Joint ranges of motion (RoM) and joint moments at the shoulder, elbow and wrist were derived using an inverse dynamics approach. The maximum absolute moments at the shoulder joint were significantly larger for the cable pulley exercises than for the bench press exercises. The cable cross-over exercise resulted in substantially different joint angles and loading patterns compared to most other exercises, with higher fluctuations during the exercise cycle. The present results indicate that a combination of bench press and cable pulley exercises are best to train the full RoM and, thus, intra-muscular coordination across the upper limbs. Care has to be taken when performing cable cross-over exercises to ensure proper stabilisation of the joints during exercise execution and avoid joint overloading.