Background: Minimum Toe Clearance (MTC) is defined as the minimum vertical distance between the lowest point under the front part of the foot and the ground, during mid-swing. Low values of MTC and walking on inclines are both related to higher probability of tripping and falling in lower limb amputees. New prosthetic designs aim at improving MTC, especially on ramps, however the real effect on MTC still needs investigation. The objective of this study was then to evaluate the effect of different prosthetic designs on MTC in inclined walking. Methods: Thirteen transtibial amputees walked on a ramp using three different prostheses: non articulating ankle (NAA), articulating hydraulic ankle (AHA), and articulating hydraulic ankle with microprocessor (AHA-MP). Median MTC, coefficient of variation (CV), and tripping probability (TP) for obstacles of 10 and 15 mm were compared across ankle type in ascent and descent. Findings: When using AHA-MP, larger MTC median values for ascending (P ≤ 0.001, W = 0.58) and descending the ramp (P = 0.003, W = 0.47) were found in the prosthetic limb. Also significantly lower CV was found on the prosthetic limb for both types of AHA feet when compared to NAA for descending the ramp (P = 0.014, W = 0.45). AHA-MP showed the lowest TP for the prosthetic leg in three conditions evaluated. On the sound limb results showed the median MTC was significantly larger (P = 0.009, W = 0.43) and CV significantly lower (P = 0.005, W = 0.41) when using an AHA in ascent. Interpretation: Both AHA prosthetic designs help reduce the risk of tripping of the prosthetic limb by increasing the median MTC, lowering its variability and reducing TP for both legs when ascending and descending the ramp. For most of the conditions, AHA-MP showed the lowest TP values. Findings suggest that AHA prostheses, especially AHA-MP could reduce the risk of tripping on ramps in amputees. [11][12][13], type of terrain [14,15] and type of shoes [15]. The changes are reflected on MTC distribution, including median, interquartile

No abstract

Analysis of the human locomotor system using rigid-body musculoskeletal models has increased in the biomechanical community with the objective of studying muscle activations of different movements. Simultaneously, the finite element method has emerged as a complementary approach for analyzing the mechanical behavior of tissues. This study presents an integrative biomechanical framework for gait analysis by linking a musculoskeletal model and a subject-specific finite element model of the pelvis. To investigate its performance, a convergence study was performed and its sensitivity to the use of non-subject-specific material properties was studied. The total hip joint force estimated by the rigid musculoskeletal model and by the finite element model showed good agreement, suggesting that the integrative approach estimates adequately (in shape and magnitude) the hip total contact force. Previous studies found movements of up to 1.4 mm in the anterior-posterior direction, for single leg stance. These results are comparable with the displacement values found in this study: 0-0.5 mm in the sagittal axis. Maximum von Mises stress values of approximately 17 MPa were found in the pelvic bone. Comparing this results with a previous study of our group, the new findings show that the introduction of muscular boundary conditions and the flexion-extension movement of the hip reduce the regions of high stress and distributes more uniformly the stress across the pelvic bone. Thus, it is thought that muscle force has a relevant impact in reducing stresses in pelvic bone during walking of the finite element model proposed in this study. Future work will focus on including other deformable structures, such as the femur and the tibia, and subject-specific material properties.