It has been technologically challenging to create an anion-exchange membrane water electrolyzer (AEMWE) that can operate efficiently without liquid electrolytes, that is, in pure water. Prior improvements in AEMWE have been limited to the development of membranes and catalysts. Here, we report an alternative solution to increase the AEMWE performance from a different perspective by developing highly conductive, macroporous layers (MPLs) as multifunctional liquid/gasdiffusion layers (LGDLs).

Measuring biological samples by atom probe tomography (APT) in their natural environment, i.e. aqueous solution, would take this analytical method, which is currently well established for metals, semi-conductive materials and non-metals, to a new level. It would give information about the 3D chemical structure of biological systems, which could enable unprecedented insights into biological systems and processes, such as virus protein interactions. For this future aim, we present as a first essential step the APT analysis of pure water (Milli-Q) which is the main component of biological systems. After Cryo-preparation, nanometric water tips are field evaporated with assistance by short laser pulses. The obtained data sets of several tens of millions of atoms reveal a complex evaporation behavior. Understanding the field evaporation process of water is fundamental for the measurement of more complex biological systems. For the identification of the individual signals in the mass spectrum, DFT calculations were performed to prove the stability of the detected molecules.

Hydrogen as an energy carrier is very versatile in energy storage applications. Developments in novel, sustainable technologies towards a CO2-free society are needed and the exploration of all-solid-state batteries (ASSBs) as well as solid-state hydrogen storage applications based on metal hydrides can provide solutions for such technologies. However, there are still many technical challenges for both hydrogen storage material and ASSBs related to designing low-cost materials with low-environmental impact. The current materials considered for all-solid-state batteries should have high conductivities for Na+, Mg2+ and Ca2+, while Al3+-based compounds are often marginalised due to the lack of suitable electrode and electrolyte materials. In hydrogen storage materials, the sluggish kinetic behaviour of solid-state hydride materials is one of the key constraints that limit their practical uses. Therefore, it is necessary to overcome the kinetic issues of hydride materials before discussing and considering them on the system level. This review summarizes the achievements of the Marie Skłodowska-Curie Actions (MSCA) innovative training network (ITN) ECOSTORE, the aim of which was the investigation of different aspects of (complex) metal hydride materials. Advances in battery and hydrogen storage materials for the efficient and compact storage of renewable energy production are discussed.

Atom Probe Tomography (APT) is currently a well-established technique to analyse the composition of solid materials including metals, semiconductors and ceramics with up to near-atomic resolution. Using an aqueous glucose solution, we now extended the technique to frozen solutions. While the mass signals of the common glucose fragments CxHy and CxOyHz overlap with (H2O)nH from water, we achieved stoichiometrically correct values via signal deconvolution. Density functional theory (DFT) calculations were performed to investigate the stability of the detected pyranose fragments. This paper demonstrates APT’s capabilities to achieve sub-nanometre resolution in tracing whole glucose molecules in a frozen solution by using cryogenic workflows. We use a solution of defined concentration to investigate the chemical resolution capabilities as a step toward the measurement of biological molecules. Due to the evaporation of nearly intact glucose molecules, their position within the measured 3D volume of the solution can be determined with sub-nanometre resolution. Our analyses take analytical techniques to a new level, since chemical characterization methods for cryogenically-frozen solutions or biological materials are limited.