Emissions were measured from seven heavy-duty (HD) on-road vehicles that were operated along six common route types used for freight transport in California. All vehicles had engines that were certified to the 0.01 g/bhp-h particulate matter (PM) and either a 0.2, 0.3, or 2.3 g/bhp-h nitrogen oxide (NOx) standard. Diesel vehicles had low carbon monoxide (CO) and total hydrocarbon (THC) emissions below brake-specific standards, with route averages ranging from 0.24 to 3.35 g CO/ mi and from 0.02 to 0.45 g THC/mi. Diesel vehicles equipped with selective catalytic reduction (SCR) had route average NOx emissions ranging from 0.58 to 3.99 g/mi (0.16 to 0.96 g/bhp-h). NOx emissions were less route-dependent for the one vehicle with a 12-L compressed natural gas (CNG) engine and threeway catalyst (TWC), with route averages ranging from 0.16 to 0.46 g/mi (0.06 to 0.13 g/bhp-h). The ranking of certification NOx emissions for the seven engines reported during enginedynamometer-based certification was not maintained during real-world testing; for example, highway driving NOx emissions were lower than certification values for some engine families and higher than certification values for others. Route-average gravimetric particulate matter (PM) emissions ranged from 4 to 12 mg/ mi, which on a brake-specific basis were at least two times below the 0.01 g/bhp-h standard. Ion speciation of PM emissions indicated that the most prevalent species were sulfate (SO 4 2− ) for the model year (MY) 2007 diesel vehicle equipped with a diesel particulate filter (DPF) and no SCR, nitrate (NO 3 − ) for conventional diesel vehicles with a DPF and SCR, and sodium (Na + ) was the most abundant species for the CNG vehicle. NOx and PM emissions were compared to, and show generally good agreement with, the latest California mobile source model (EMFAC2014).
Chassis dynamometer emissions testing of 11 heavy-duty goods movement vehicles, including diesel, natural gas, and dual-fuel technology, compliant with US-EPA 2010 emissions standard were conducted. Results of the study show that three-way catalyst (TWC) equipped stoichiometric natural gas vehicles emit 96% lower NOx emissions as compared to selective catalytic reduction (SCR) equipped diesel vehicles. Characteristics of drayage truck vocation, represented by the near-dock and local drayage driving cycles, were linked to high NOx emissions from diesel vehicles equipped with a SCR. Exhaust gas temperatures below 250 °C, for more than 95% duration of the local and near-dock driving cycles, resulted in minimal SCR activity. The low percentage of activity SCR over the local and near-dock cycles contributed to a brake-specific NOx emissions that were 5-7 times higher than in-use certification limit. The study also illustrated the differences between emissions rate measured from chassis dynamometer testing and prediction from the EMFAC model. The results of the study emphasize the need for model inputs relative to SCR performance as a function of driving cycle and engine operation characteristics.
An experimental investigation was conducted to determine the emissions characteristics of higher alcohols and gasoline (UTG96) blends. While lower alcohols (methanol and ethanol) have been used in blends with gasoline, very little work has been done or reported on higher alcohols (propanol, butanol and pentanol). Comparisons of emissions and fuel characteristics between higher alcohol/gasoline blends and neat gasoline were made to determine the advantages and disadvantages of blending higher alcohols with gasoline. All tests were conducted on a single-cylinder Waukesha Cooperative Fuel Research engine operating at steady state conditions and stoichiometric air-fuel (A/F) ratio. Emissions tests were conducted at the optimum spark timing-knock limiting compression ratio combination for the particular blend being tested. The cycle emissions [mass per unit time (g/h)] of CO, CO2 and organic matter hydrocarbon equivalent (OMHCE) from the higher alcohol/gasoline blends were very similar to those from neat gasoline. Cycle emissions of NOx from the blends were higher than those from neat gasoline. However, for all the emissions species considered, the brake specific emissions (g/kW h) were significantly lower for the higher alcohol/gasoline blends than for neat gasoline. This was because the blends had greater resistance to knock and allowed higher compression ratios, which increased engine power output. The contribution of alcohols and aldehydes to the overall OMHCE emissions was found to be minimal. Cycle fuel consumption (g/h) of higher alcohol/gasoline blends was slightly higher than with neat gasoline due to the lower stoichiometric A/F ratios required by the blends. However, the brake specific fuel consumption (g/kW h) for the blends was significantly lower than that for neat gasoline.
Experiments were conducted to characterize the particulate matter (PM)-size distribution, number concentration, and chemical composition emitted from transit buses powered by a USEPA 2010 compliant, stoichiometric heavy-duty natural gas engine equipped with a three-way catalyst (TWC). Results of the particle-size distribution showed a predominant nucleation mode centered close to 10 nm. PM mass in the size range of 6.04 to 25.5 nm correlated strongly with mass of lubrication-oil-derived elemental species detected in the gravimetric PM sample. Results from oil analysis indicated an elemental composition that was similar to that detected in the PM samples. The source of elemental species in the oil sample can be attributed to additives and engine wear. Chemical speciation of particulate matter (PM) showed that lubrication-oil-based additives and wear metals were a major fraction of the PM mass emitted from the buses. The results of the study indicate the possible existence of nanoparticles below 25 nm formed as a result of lubrication oil passage through the combustion chamber. Furthermore, the results of oxidative stress (OS) analysis on the PM samples indicated strong correlations with both the PM mass calculated in the nanoparticle-size bin and the mass of elemental species that can be linked to lubrication oil as the source.
The experiments aimed at investigating the effect of real-world engine load conditions on nanoparticle emissions from a Diesel Particulate Filter and Selective Catalytic Reduction after-treatment system (DPF-SCR) equipped heavy-duty diesel engine. The results showed the emission of nucleation mode particles in the size range of 6-15 nm at conditions with high exhaust temperatures. A direct result of higher exhaust temperatures (over 380 °C) contributing to higher concentration of nucleation mode nanoparticles is presented in this study. The action of an SCR catalyst with urea injection was found to increase the particle number count by over an order of magnitude in comparison to DPF out particle concentrations. Engine operations resulting in exhaust temperatures below 380 °C did not contribute to significant nucleation mode nanoparticle concentrations. The study further suggests the fact that SCR-equipped engines operating within the Not-To-Exceed (NTE) zone over a critical exhaust temperature and under favorable ambient dilution conditions could contribute to high nanoparticle concentrations to the environment. Also, some of the high temperature modes resulted in DPF out accumulation mode (between 50 and 200 nm) particle concentrations an order of magnitude greater than typical background PM concentrations. This leads to the conclusion that sustained NTE operation could trigger high temperature passive regeneration which in turn would result in lower filtration efficiencies of the DPF that further contributes to the increased solid fraction of the PM number count.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.