Ionic-liquid (IL) mixtures hold great promise, as they allow liquids with a wide range of properties to be formed by mixing two common components rather than by synthesizing a large array of pure ILs with different chemical structures. In addition, these mixtures can exhibit a range of properties and structural organization that depend on their composition, which opens up new possibilities for the composition-dependent control of IL properties for particular applications. However, the fundamental properties, structure, and dynamics of IL mixtures are currently poorly understood, which limits their more widespread application. This article presents the first comprehensive investigation into the bulk and surface properties of IL mixtures formed from two commonly encountered ILs: 1-ethyl-3-methylimidazolium and 1-dodecyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide ([Cmim][TfN] and [Cmim][TfN]). Physical property measurements (viscosity, conductivity, and density) reveal that these IL mixtures are not well described by simple mixing laws, implying that their structure and dynamics are strongly composition dependent. Small-angle X-ray and neutron scattering measurements, alongside molecular dynamics (MD) simulations, show that at low mole fractions of [Cmim][TfN], the bulk of the IL is composed of small aggregates of [Cmim] ions in a [Cmim][TfN] matrix, which is driven by nanosegregation of the long alkyl chains and the polar parts of the IL. As the proportion of [Cmim][TfN] in the mixtures increases, the size and number of aggregates increases until the C12 alkyl chains percolate through the system and a bicontinuous network of polar and nonpolar domains is formed. Reactive atom scattering-laser-induced fluorescence experiments, also supported by MD simulations, have been used to probe the surface structure of these mixtures. It is found that the vacuum-IL interface is enriched significantly in C12 alkyl chains, even in mixtures low in the long-chain component. These data show, in contrast to previous suggestions, that the [Cmim] ion is surface active in this binary IL mixture. However, the surface does not become saturated in C12 chains as its proportion in the mixtures increases and remains unsaturated in pure [Cmim][TfN].
ReuseItems deposited in White Rose Research Online are protected by copyright, with all rights reserved unless indicated otherwise. They may be downloaded and/or printed for private study, or other acts as permitted by national copyright laws. The publisher or other rights holders may allow further reproduction and re-use of the full text version. This is indicated by the licence information on the White Rose Research Online record for the item. TakedownIf you consider content in White Rose Research Online to be in breach of UK law, please notify us by emailing eprints@whiterose.ac.uk including the URL of the record and the reason for the withdrawal request. This is an Accepted Manuscript, which has been through the Royal Society of Chemistry peer review process and has been accepted for publication.Accepted Manuscripts are published online shortly after acceptance, before technical editing, formatting and proof reading. Using this free service, authors can make their results available to the community, in citable form, before we publish the edited article. We will replace this Accepted Manuscript with the edited and formatted Advance Article as soon as it is available.You can find more information about Accepted Manuscripts in the Information for Authors.Please note that technical editing may introduce minor changes to the text and/or graphics, which may alter content. The journal's standard Terms & Conditions and the Ethical guidelines still apply. In no event shall the Royal Society of Chemistry be held responsible for any errors or omissions in this Accepted Manuscript or any consequences arising from the use of any information it contains. Accepted Manuscript Faraday Discussions www.rsc.org/faraday_d Faraday Discussions Royal Society of ChemistryThis manuscript will be presented and discussed at a forthcoming Faraday Discussion meeting. All delegates can contribute to the discussion which will be included in the final volume.Register now to attend! Full details of all upcoming meetings: http://rsc.li/fd-upcoming-meetings This is an Accepted Manuscript, which has been through the Royal Society of Chemistry peer review process and has been accepted for publication.Accepted Manuscripts are published online shortly after acceptance, before technical editing, formatting and proof reading. Using this free service, authors can make their results available to the community, in citable form, before we publish the edited article. We will replace this Accepted Manuscript with the edited and formatted Advance Article as soon as it is available.You can find more information about Accepted Manuscripts in the Information for Authors.Please note that technical editing may introduce minor changes to the text and/or graphics, which may alter content. The journal's standard Terms & Conditions and the Ethical guidelines still apply. In no event shall the Royal Society of Chemistry be held responsible for any errors or omissions in this Accepted Manuscript or any consequences arising from the use of any information it contains....
ABSTRACT:In order to seek the balance point between liquid crystalline and high efficiency emission, two novel aggregation-induced emission-based (AIE) liquid crystal materials of TPE-PBN and TPE-2PBN, which contains tetraphenylethene derivative as the emission core and 4-cynobiphenyl moiety as the mesogenic unit, were designed and prepared. Both simple molecules showed a mesophase at high temperature evidenced by polarised optical microscopy (POM), differential scanning calorimetry (DSC) and temperature-dependent X-ray diffraction (XRD).Simultaneously, TPE-PBN and TPE-2PBN presented clearly AIE characteristics in the blueishgreen region and achieved the high emission quantum efficiency of 71% and 83% in solid state, respectively. Due to the self-assembly property of thermotropic liquid crystals, both compounds showed higher hole mobilities in the annealed films than in pristine films. Employing TPE-PBN and TPE-2PBN as the emitting materials, both non-doped devices and doped devices were fabricated. The TPE-PBN-based doped OLEDs showed a better device performance with an external quantum efficiency (EQE) of 4.1% which is among the highest EQE of the blue AIE fluorescent OLEDs.
Blue- and green-emitting cyclometalated liquid-crystalline iridium complexes are realized by using a modular strategy based on strongly mesogenic groups attached to an acetylacetonate ancillary ligand. The cyclometalated ligand dictates the photophysical properties of the materials, which are identical to those of the parent complexes. High hole mobilities, up to 0.004 cm(2) V(-1) s(-1), were achieved after thermal annealing, while amorphous materials show hole mobilities of only approximately 10(-7) -10(-6) cm(2) V(-1) s(-1), similar to simple iridium complexes. The design strategy allows the facile preparation of phosphorescent liquid-crystalline complexes with fine-tuned photophysical properties.
The preparation of mixtures of ionic liquids (ILs) represents an attractive strategy to tune their properties and an important aspect is to understand how the structure of the bulk varies...
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.