Layered LiNi x Mn y Co z O 2 (NMC) is a widely used class of cathode materials with LiNi 1/3 Mn 1/3 Co 1/3 O 2 (NMC111) being the most common representative. However, Ni-rich NMCs are more and more in the focus of current research due to their higher specific capacity and energy. In this work we will compare LiNi 1/3 Mn 1/3 Co 1/3 O 2 (NMC111), LiNi 0.6 Mn 0.2 Co 0.2 O 2 (NMC622), and LiNi 0.8 Mn 0.1 Co 0.1 O 2 (NMC811) with respect to their cycling stability in NMC-graphite full-cells at different end-of-charge potentials. It will be shown that stable cycling is possible up to 4.4 V for NMC111 and NMC622 and only up to 4.0 V for NMC811. At higher potentials, significant capacity fading was observed, which was traced back to an increase in the polarization of the NMC electrode, contrary to the nearly constant polarization of the graphite electrode. Furthermore, we show that the increase in the polarization occurs when the NMC materials are cycled up to a high-voltage feature in the dq/dV plot, which occurs at ∼4.7 V vs. Li/Li + for NMC111 and NMC622 and at ∼4.3 V vs. Li/Li + for NMC811. For the latter material, this feature corresponds to the H2 → H3 phase transition. Contrary to the common understanding that the electrochemical oxidation of carbonate electrolytes causes the CO 2 and CO evolution at potentials above 4.7 V vs. Li/Li + , we believe that the observed CO 2 and CO are mainly due to the chemical reaction of reactive lattice oxygen with the electrolyte. This hypothesis is based on gas analysis using On-line Electrochemical Mass Spectrometry (OEMS), by which we prove that all three materials release oxygen from the particle surface and that the oxygen evolution coincides with the onset of CO 2 and CO evolution. Interestingly, the onsets of oxygen evolution for the different NMCs correlate well with the high-voltage redox feature at ∼4.7 V vs. Li/Li + for NMC111 and NMC622 as well as at ∼4.3 V vs. Li/Li + for NMC811. To support this hypothesis, we show that no CO 2 or CO is evolved for the LiNi 0.43 Mn 1.57 O 4 (LNMO) spinel up to 5 V vs. Li/Li + , consistent with the absence of oxygen release. Lastly, we demonstrate by the use of 13 C labeled conductive carbon that it is the electrolyte rather than the conductive carbon which is oxidized by the released lattice oxygen. Taking these findings into consideration, a mechanism is proposed for the reaction of released lattice oxygen with ethylene carbonate yielding CO 2 , CO, and Li-Ion batteries have recently been used as power supply for electric vehicles (EVs). In order to penetrate the mass market, a significant reduction in costs and further performance improvements have to be achieved to realize a longer driving range of EVs.1 The latter highly depends on the choice of the cathode active material, for which several potential materials exist, 2 of which layered lithium nickel manganese cobalt oxide (LiNi x Mn y Co z O 2 , NMC) is one of the most promising class of cathode materials.3 This is due to the high specific capacity and good stability of the lay...

We compare the stability of alkyl carbonate electrolyte on NMC111, -622, and -811, LNMO, and conductive carbon electrodes. We prove that CO and CO evolution onset potentials depend on the electrode material and increase in the order NMC811 < NMC111 ≈ NMC622 < conductive carbon ≈ LNMO, which we rationalize by two fundamentally different oxidation mechanisms, the chemical and the electrochemical electrolyte oxidation. Additionally, in contrast to the widespread understanding that transition metals in cathode active materials catalyze the electrolyte oxidation, we will prove that such a catalytic effect on the electrochemical electrolyte oxidation does not exist.

is one of the high-energy positive electrode (cathode) materials for next generation Li-ion batteries. However, compared to the structurally similar LiNi 1/3 Mn 1/3 Co 1/3 O 2 (NMC111), it can suffer from a shorter lifetime due to its higher surface reactivity. This work studied and compared the formation of surface contaminations on NMC811 and NMC111 when stored under ambient conditions using electrochemical cycling, Raman spectroscopy, and X-ray photoelectron spectroscopy. NMC811 was found to develop a surface layer of up to ∼10 nm thickness that was mostly composed of nickel carbonate species mixed with minor quantities of hydroxide and water after ambient storage for 1 year, while no significant changes were observed on the NMC111 surface. The amount of carbonate species was quantified by gas chromatographic (GC) detection of carbon dioxide generated when the NMC particles were dispersed in hydrochloric acid. Surface impurity species formed on NMC811 upon ambient storage not only lead to a significant delithiation voltage peak in the first charge, but also markedly reduce the cycling stability of NMC811-graphite cells due to significantly growing polarization of the NMC811 electrode.

The electrolyte additive fluoroethylene carbonate (FEC) is known to significantly improve the lifetime of Li-ion batteries with silicon anodes. In this work, we show that FEC can indeed improve the lifetime of silicon-carbon composite anodes but is continuously consumed during electrochemical cycling. By the use of 19 F-NMR spectroscopy and charge/discharge cycling we demonstrate that FEC is only capable to stabilize the cell performance as long as FEC is still remaining in the cell. Its total consumption causes a significant increase of the cell polarization leading to a rapid capacity drop. We show with On-line Electrochemical Mass Spectrometry (OEMS) that the presence of FEC in the electrolyte prohibits the reduction of other electrolyte components almost entirely. Consequently, the cumulative irreversible capacity until the rapid capacity drop correlates linearly with the specific amount of FEC (in units of μmol FEC /mg electrode ) in the cell. The latter quantity therefore determines the lifetime of silicon anodes rather than the concentration of FEC in the electrolyte. By correlating the cumulative irreversible capacity and the specific amount of FEC in the cell, we present an easy tool to predict how much cumulative irreversible capacity can be tolerated until all FEC will be consumed in either half-cells or full-cells. We further demonstrate that four electrons are consumed for the reduction of one FEC molecule and that one carbon dioxide molecule is released for every FEC molecule that is reduced. Using all information from this study and combining it with previous reports in literature, a new reductive decomposition mechanism for FEC is proposed yielding CO 2 , LiF, In the emerging market of electric vehicles (EVs), the development of batteries with higher energy density and improved cycle-life is essential.1 However, their penetration of the mass market significantly depends on cost and the available driving range.2 The US Advanced Battery Consortium (USABC) defined the target value of 235 Wh/kg (at a C/3 rate) on a battery level until 2020.3 As outlined in the recent review by Andre et al., 4 reaching this goal requires an increase of the energy density of today's batteries by a factor of roughly 2 to 2.5 and can only be achieved by the development and integration of novel anode and cathode active materials. A critical element to reach this goal is the implementation of anode active materials with much higher specific capacity than currently used graphite anodes (372 mAh/g 1,5,6 ), with silicon being considered as the most likely next generation anode material due to its high natural abundance and very high theoretical specific capacity of roughly 3600 mAh/g (corresponding to the Li 15 Si 4 phase 7 ). The alloying of silicon with lithium is accompanied by large structural changes, resulting in a volume increase by 310% upon full lithiation.5,7-11 These huge volumetric changes upon lithium insertion and extraction are responsible for the generally shorter cycle-life of silicon electrode materials comp...

Transition metal dissolution from the cathode active material and its deposition on the anode causes significant cell aging, studied most intensively for manganese. Owing to their higher specific energy, the current focus is shifting towards nickel-rich layered LiNi x Mn y Co z O 2 (NMC, x + y + z = 1) with x > 0.5, so that the effect of Ni dissolution on cell degradation needs to be understood. This study investigates the dissolution of transition metals from a NMC622 cathode and their subsequent deposition on a graphite anode using operando X-ray absorption spectroscopy. We show that in NMC622-graphite cells transition metals dissolve nearly stoichiometrically at potentials >4.6 V, highlighting the significance of investigating Ni dissolution/deposition. Using NMC622graphite full-cells with electrolyte containing the bis(trifluoromethane)sulfonimide (TFSI) salts of either Ni, Mn, or Co, we compare the detrimental impact of these metals on cell performance. Using in-situ and ex-situ XRD, we show that the aging mechanism induced by all three metals is the loss of cycleable lithium in the solid electrolyte interface (SEI) of the graphite. This loss is larger in magnitude when Mn is present in the electrolyte compared to Ni and Co, which we ascribe to a higher activity of deposited Mn towards SEI decomposition in comparison to Ni and Co.