Quantitative information regarding the endmember composition of the gas and oil that flowed from the Macondo well during the Deepwater Horizon oil spill is essential for determining the oil flow rate, total oil volume released, and trajectories and fates of hydrocarbon components in the marine environment. Using isobaric gas-tight samplers, we collected discrete samples directly above the Macondo well on June 21, 2010, and analyzed the gas and oil. We found that the fluids flowing from the Macondo well had a gas-to-oil ratio of 1,600 standard cubic feet per petroleum barrel. Based on the measured endmember gas-to-oil ratio and the Federally estimated net liquid oil release of 4.1 million barrels, the total amount of C 1 -C 5 hydrocarbons released to the water column was 1.7 × 10 11 g. The endmember gas and oil compositions then enabled us to study the fractionation of petroleum hydrocarbons in discrete water samples collected in June 2010 within a southwest trending hydrocarbon-enriched plume of neutrally buoyant water at a water depth of 1,100 m. The most abundant petroleum hydrocarbons larger than C 1 -C 5 were benzene, toluene, ethylbenzene, and total xylenes at concentrations up to 78 μg L −1 . Comparison of the endmember gas and oil composition with the composition of water column samples showed that the plume was preferentially enriched with water-soluble components, indicating that aqueous dissolution played a major role in plume formation, whereas the fates of relatively insoluble petroleum components were initially controlled by other processes.Gulf of Mexico | subsurface plumes D uring the 3 mo following April 20, 2010, the Macondo well emitted several million barrels of gas and oil at the seafloor of the Gulf of Mexico following the sinking of the Deepwater Horizon drilling platform. Relative to oil spills occurring at the sea surface, petroleum hydrocarbons experienced a unique set of processes following their release at 1.5-km depth (1-4). This spill demonstrates the importance of interwoven chemical, physical, and biological processes in regulating the transport and fate of hydrocarbons in the deep marine environment. Compositional information for petroleum (gas and oil) released by the well at the seafloor is essential for evaluating the fates of hydrocarbons in the sea. Moreover, such information provides direct constraints on estimates of the total mass of individual hydrocarbons released to the environment and the flow rates at the site of the spill (5). Gases are of particular interest because the gas fraction represents a large component of the carbon released, and it was biodegraded rapidly in the water column (3, 4). Compositional data for released oil is also necessary for forensic analyses when distinguishing Macondo well oil from hydrocarbons released from other sources in the Gulf of Mexico.Numerous studies have examined factors that influence the compositional evolution of oil spilled at the sea surface (6-10), where evaporation and dissolution may simultaneously remove hydrocarbons fr...

Following the Deepwater Horizon disaster, the effect of weathering on surface slicks, oil-soaked sands, and oil-covered rocks and boulders was studied for 18 months. With time, oxygen content increased in the hydrocarbon residues. Furthermore, a weathering-dependent increase of an operationally defined oxygenated fraction relative to the saturated and aromatic fractions was observed. This oxygenated fraction made up >50% of the mass of weathered samples, had an average carbon oxidation state of −1.0, and an average molecular formula of (C 5 H 7 O) n . These oxygenated hydrocarbon residues were devoid of natural radiocarbon, confirming a fossil source and excluding contributions from recent photosynthate. The incorporation of oxygen into the oil's hydrocarbons, which we refer to as oxyhydrocarbons, was confirmed from the detection of hydroxyl and carbonyl functional groups and the identification of long chain (C 10 −C 32 ) carboxylic acids as well as alcohols. On the basis of the diagnostic ratios of alkanes and polycyclic aromatic hydrocarbons, and the context within which these samples were collected, we hypothesize that biodegradation and photooxidation share responsibility for the accumulation of oxygen in the oil residues. These results reveal that molecular-level transformations of petroleum hydrocarbons lead to increasing amounts of, apparently recalcitrant, oxyhydrocarbons that dominate the solvent-extractable material from oiled samples.

Petroleum biomarkers such as hopanoids, steranes, and triaromatic steroids (TAS) are commonly used to investigate the source and fate of petroleum hydrocarbons in the environment based on the premise that these compounds are resistant to biotic and abiotic degradation. To test the validity of this premise in the context of the Deepwater Horizon disaster, we investigated changes to these biomarkers as induced by natural weathering of crude oil discharged from the Macondo Well (MW). For surface slicks collected from May to June in 2010, and other oiled samples collected on beaches in the northern Gulf of Mexico from July 2010 until August 2012, hopanoids with up to 31 carbons as well as steranes and diasteranes were not systematically affected by weathering processes. In contrast, TAS and C32- to C35-homohopanes were depleted in all samples relative to 17α(H),21β(H)-hopane (C30-hopane). Compared to MW oil, C35-homohopanes and TAS were depleted by 18 ± 10% and 36 ± 20%, respectively, in surface slicks collected from May to June 2010, and by 37 ± 9% and 67 ± 10%, respectively, in samples collected along beaches from April 2011 through August 2012. Based on patterns of relative losses of individual compounds, we hypothesize biodegradation and photooxidation as main degradation processes for homohopanes and TAS, respectively. This study highlights that (i) TAS and homohopanes can be degraded within several years following an oil spill, (ii) the use of homohopanes and TAS for oil spill forensics must account for degradation, and (iii) these compounds provide a window to parse biodegradation and photooxidation during advanced stages of oil weathering.

Biodegradation plays a major role in the natural attenuation of oil spills. However, limited information is available about biodegradation of different saturated hydrocarbon classes in surface environments, despite that oils are composed mostly of saturates, due to the limited ability of conventional gas chromatography (GC) to resolve this compound group. We studied eight weathered oil samples collected from four Gulf of Mexico beaches 12-19 months after the Deepwater Horizon disaster. Using comprehensive two-dimensional gas chromatography (GC × GC), we successfully separated, identified, and quantified several distinct saturates classes in these samples. We find that saturated hydrocarbons eluting after n-C22 dominate the GC-amenable fraction of these weathered samples. This compound group represented 8-10%, or 38-68 thousand metric tons, of the oil originally released from Macondo well. Saturates in the n-C22 to n-C29 elution range were found to be partly biodegraded, but to different relative extents, with ease of biodegradation decreasing in the following order: n-alkanes > methylalkanes and alkylcyclopentanes+alkylcyclohexanes > cyclic and acyclic isoprenoids. We developed a new quantitative index designed to characterize biodegradation of >n-C22 saturates. These results shed new light onto the environmental fate of these persistent, hydrophobic, and mostly overlooked compounds in the unresolved complex mixtures (UCM) of weathered oils.

No abstract