Abstract-We report characterization results for an engineering prototype of a next-generation low-frequency radio astronomy array. This prototype, which we refer to as the Aperture Array Verification System 0.5 (AAVS0.5), is a sparse pseudo-random array of 16 log-periodic antennas designed for 70-450 MHz. It is co-located with the Murchison Widefield Array (MWA) at the Murchison Radioastronomy Observatory (MRO) near the Australian Square Kilometre Array (SKA) core site. We characterize the AAVS0.5 using two methods: in-situ radio interferometry with astronomical sources and an engineering approach based on detailed full-wave simulation. Insitu measurement of the small prototype array is challenging due to the dominance of the Galactic noise and the relatively weaker calibration sources easily accessible in the southern sky. The MWA, with its 128 "tiles" and up to 3 km baselines, enabled in-situ measurement via radio interferometry. We present array sensitivity and beam pattern characterization results and compare to detailed full-wave simulation. We discuss areas where differences between the two methods exist and offer possibilities for improvement. Our work demonstrates the value of the dual astronomy-simulation approach in upcoming SKA design work.

We describe the design and performance of the Engineering Development Array (EDA), which is a low frequency radio telescope comprising 256 dual-polarisation dipole antennas working as a phased-array. The EDA was conceived of, developed, and deployed in just 18 months via re-use of Square Kilometre Array (SKA) precursor technology and expertise, specifically from the Murchison Widefield Array (MWA) radio telescope. Using drift scans and a model for the sky brightness temperature at low frequencies, we have derived the EDA's receiver temperature as a function of frequency. The EDA is shown to be sky-noise limited over most of the frequency range measured between 60 and 240 MHz. By using the EDA in interferometric mode with the MWA, we used calibrated visibilities to measure the absolute sensitivity of the array. The measured array sensitivity matches very well with a model based on the array layout and measured receiver temperature. The results demonstrate the practicality and feasibility of using MWA-style precursor technology for SKA-scale stations. The modular architecture of the EDA allows upgrades to the array to be rolled out in a staged approach. Future improvements to the EDA include replacing the second stage beamformer with a fully digital system, and to transition to using RF-over-fibre for the signal output from first stage beamformers.

No abstract