Voice quality is strongly dependent on vocal fold dynamics, which in turn are dependent on lung pressure and vocal fold biomechanics. Numerical and physical models are often used to investigate the interactions of these different subsystems. However, the utility of numerical and physical models is limited unless appropriately validated with data from physiological models. Hence a method that enables analysis of local vocal fold deformations along the entire surface is presented. In static tensile tests, forces are applied to distinctive working points being located in cover and muscle, respectively, so that specific layer properties can be investigated. The forces are directed vertically upward and are applied along or above the vocal fold edge. The resulting deformations are analyzed using multiple perspectives and three-dimensional reconstruction. Deformation characteristics of four human vocal folds were investigated. Preliminary results showed two phases of deformation: a range with a small slope for small deformations fading into a significant nonlinear deformation trend with a high slope. An increase of tissue stiffness from posterior to anterior was detected. This trend is more significant for muscle and in the mid-anterior half of the vocal fold.

After total larynx excision due to laryngeal cancer, the tracheoesophageal substitute tissue vibrations at the intersection between the pharynx and the esophagus [pharyngoesophageal segment (PE segment)] serve as voice generator. The quality of the substitute voice significantly depends on the vibratory characteristics of the PE segment. For improving voice rehabilitation, the relationship between the PE dynamics and the resulting substitute voice quality is a matter of particular interest. Precondition for a comprehensive analysis of this relationship is an objective quantification of the PE vibrations. For quantification purposes, a method is proposed, which is based on the reproduction of the tissue vibrations by means of a biomechanical model of the PE segment. An optimization procedure for an automatic determination of appropriate model parameters is suggested to adapt the model dynamics to tissue movements extracted from high-speed (HS) videos. The applicability of the optimization procedure is evaluated with ten synthetic data sets. A mean error of 8.2% for the determination of previously defined model parameters was achieved as well as an overall stability of 7.1%. The application of the model to six HS recordings presented a mean correlation of the vibration patterns of 82%.

For the analysis of vocal fold dynamics, sub- and supra glottal influences must be taken into account, as recent studies have shown. In this work, we analyze the influence of changes in the epi-laryngeal area on vocal fold dynamics. We investigate two excised female larynges in a hemi-larynx set-up combined with a synthetic vocal tract consisting of hard plastic and simulating the vowel /a/. Eigenmodes, amplitudes, and velocities of the oscillations, the sub-glottal pressures and sound pressure levels of the generated signal are investigated as function of three distinctive epi-laryngeal areas (28.4 mm2, 71.0 mm2 and 205.9 mm2). The results showed that the sound-pressure level is independent of the epi-larynx cross-section and exhibits a non-linear relation to the insufflated air flow. The sub-glottal pressure decreased with an increase in the epi-laryngeal area and displayed linear relations to the air flow. The principal eigenfunctions from the vocal fold dynamics exhibited lateral movement for the first Eigenfunction and rotational motion for the second Eigenfunction. In total, the first two Eigenfunctions (EEF) covered a minimum of 60% of the energy, with an average of more than 50% for the first Eigenfunction. Correlations to epilarynx areas were not found. Maximal values for amplitudes (up to 2.5 mm) and velocities (up to 1.57 mm/ms) changed with varying epilaryngeal area, but did not show consistent behaviour for both larynges. We conclude that the size of the epi-laryngeal area has significant influence on vocal fold dynamics, but does not significantly affect the resultant sound-pressure level.

Laryngeal cancer due to, e.g., extensive smoking and/or alcohol consumption can necessitate the excision of the entire larynx. After such a total laryngectomy, the voice generating structures are lost and with that the quality of life of the concerning patients is drastically reduced. However, the vibrations of the remaining tissue in the so called pharyngoesophageal (PE) segment can be applied as alternative sound generator. Tissue, scar, and geometric aspects of the PE-segment determine the postoperative substitute voice characteristic, being highly important for the future live of the patient. So far, PE-dynamics are simulated by a biomechanical model which is restricted to stationary vibrations, i.e., variations in pitch and amplitude cannot be handled. In order to investigate the dynamical range of PE-vibrations, knowledge about the temporal processes during substitute voice production is of crucial interest. Thus, time-dependent model parameters are suggested in order to quantify non-stationary PE-vibrations and drawing conclusions on the temporal characteristics of tissue stiffness, oscillating mass, pressure, and geometric distributions within the PE-segment. To adapt the numerical model to the PE-vibrations, an automatic, block-based optimization procedure is applied, comprising a combined global and local optimization approach. The suggested optimization procedure is validated with 75 synthetic data sets, simulating non-stationary oscillations of differently shaped PE-segments. The application to four high-speed recordings is shown and discussed. The correlation between model and PE-dynamics is ≥ 97%.

Understanding vocal fold dynamics presents an essential part in treating voice disorders as it is the prerequisite to appropriate medical therapy. Various physical and numerical models exist for simulation purposes, all relying on simplified material parameters. To improve current approaches, data of realistic tissue behavior, i.e., in natural surroundings, have to be considered in model development. An in vitro setup was proposed for tensile tests combined with an optical method for precise, local and metrical 3-D measurements of distinctive surface points. Compared to previous 3-D reconstruction methods, the accuracy was improved tenfold. Vertically applied forces versus resulting deformation were measured for ten porcine vocal folds. Deformation characteristics of mucosa and the two-layer structure of mucosa and muscle (MM) were investigated at three distinctive locations along the vocal fold edge. The spring rates were represented by an exponential function. For equal deflections, an increasing spring rate from posterior to anterior for MM was measured. For solely mucosa, the spring rate decreased from the posterior to the middle and subsequently increased again. The MM-layer presented a stiffer deformation behavior than mucosa. For deformations higher than 1.5 mm, the spring rates for MM were more than twice as high as for mucosa. The investigations display the importance of considering both multilayers and local differences for the improvement of vocal fold models.