No abstract

Results are reported from a joint analysis of Phase I and Phase II data from the Sudbury Neutrino Observatory. The effective electron kinetic energy threshold used is T eff = 3.5 MeV, the lowest analysis threshold yet achieved with water Cherenkov detector data. In units of 10 6 cm −2 s −1 , the total flux of active-flavor neutrinos from 8 B decay in the Sun measured using the neutral current (NC) reaction of neutrinos on deuterons, with no constraint on the 8 B neutrino energy spectrum, is found to be NC = 5.140 +0.160 −0.158 (stat) +0.132 −0.117 (syst). These uncertainties are more than a factor of 2 smaller than previously published results. Also presented are the spectra of recoil electrons from the charged current reaction of neutrinos on deuterons and the elastic scattering of electrons. A fit to the Sudbury Neutrino Observatory data in which the free parameters directly describe the total 8 B neutrino flux and the energy-dependent ν e survival probability provides a measure of the total 8

The Sudbury Neutrino Observatory (SNO) used an array of 3 He proportional counters to measure the rate of neutral-current interactions in heavy water and precisely determined the total active (ν x ) 8 B solar neutrino flux. This technique is independent of previous methods employed by SNO The Sudbury Neutrino Observatory [1] detects 8 B solar neutrinos through three reactions: charged-current interactions (CC) on deuterons, in which only electron neutrinos participate; neutrino-electron elastic scattering (ES), which are dominated by contributions from electron neutrinos; and neutral-current (NC) disintegration of the deuteron by neutri-

No abstract

The Sudbury Neutrino Observatory (SNO) has precisely determined the total active (ν x ) 8 B solar neutrino flux without assumptions about the energy dependence of the ν e survival probability. The measurements were made with dissolved NaCl in the heavy water to enhance the sensitivity and signature for neutral-current interactions. The flux is found to be 5.21 ± 0.27 (stat) ± 0.38 (syst) × 10 6 cm −2 s −1 , in agreement with previous measurements and standard solar models. A global analysis of these and other solar and reactor neutrino results yields ∆m 2 = 7.1 +1.2 −0.6 × 10 −5 eV 2 and θ = 32.5 +2. ES).Only electron neutrinos produce charged-current interactions (CC), while the neutral-current (NC) and elastic scattering (ES) reactions have sensitivity to non-electron flavors. The NC reaction measures the total flux of all active neutrino flavors above a threshold of 2.2 MeV. SNO previously measured the NC rate by observing neutron captures on deuterons, and found that a Standard-Model description with an undistorted 8 B neutrino spectrum and CC, ES, and NC rates due solely to ν e interactions was rejected [2, 3]. This Letter presents measurements of the CC, NC, and ES rates from SNO's dissolved salt phase.The addition of 2 tonnes of NaCl to the kilotonne of heavy water increased the neutron capture efficiency and the associated Cherenkov light. The solution was thoroughly mixed and

The focal-plane detector system for the KArlsruhe TRItium Neutrino (KATRIN) experiment consists of a multi-pixel silicon p-i-n-diode array, custom readout electronics, two superconducting solenoid magnets, an ultra high-vacuum system, a high-vacuum system, calibration and monitoring devices, a scintillating veto, and a custom data-acquisition system. It is designed to detect the low-energy electrons selected by the KATRIN main spectrometer. We describe the system and summarize its performance after its final installation.Comment: 28 pages. Two figures revised for clarity. Final version published in Nucl. Inst. Meth.

The KArlsruhe TRItium Neutrino (KATRIN) experiment, which aims to make a direct and model-independent determination of the absolute neutrino mass scale, is a complex experiment with many components. More than 15 years ago, we published a technical design report (TDR) [1] to describe the hardware design and requirements to achieve our sensitivity goal of 0.2 eV at 90% C.L. on the neutrino mass. Since then there has been considerable progress, culminating in the publication of first neutrino mass results with the entire beamline operating [2]. In this paper, we document the current state of all completed beamline components (as of the first neutrino mass measurement campaign), demonstrate our ability to reliably and stably control them over long times, and present details on their respective commissioning campaigns. K: Beam-line instrumentation (beam position and profile monitors, beam-intensity monitors, bunch length monitors); Spectrometers; Gas systems and purification; Neutrino detectors A X P : 2103.04755Neutrino-mass mode. This is the standard mode of operation to continually adjust the retarding voltage of the MS in the range of [ 0 − 40 eV; 0 + 50 eV] while tritium is in the system. This scanning range can be adjusted if required. The voltage and the time spent at each setting are defined by the Measurement Time Distribution (MTD) (figure 3). A typical run at a given voltage lasts between 20 s and 600 s; a full scan of the energy range given above takes about 2 h. Of these standard neutrino-mass runs, a small portion will be dedicated to sterile neutrino searches. These searches involve scanning much farther (order of keV) below the endpoint 0 .Calibration mode. To check the long-term system stability, calibration measurements are done regularly. The neutrino-mass mode is suspended for the duration of these measurement:• An energy calibration of the FPD (section 6) is performed weekly, which requires closing off the detector system from the main beamline for about 4 h.• The offset and the gain correction factor of the low-voltage readout in the high-voltage measurement chain needs to be calibrated based on standard reference sources (section 5.3.4). This requires stopping the precision monitoring of the MS retarding potential twice per week for about 0.5 h each.

No abstract