A large number of studies have demonstrated that mechanical perturbation modulates cellular metabolism; however, the systematic characterization of the molecular and cellular transduction mechanisms underlying mechanically induced metabolic modulation has been impeded, in part, by the limitations of the mechanical device. The objective of this investigation was to develop an in vitro experimental system that would provide independent control of the spatial and temporal biaxial strain distribution imposed on a flexible transparent tissue culture membrane that permits attachment, proliferation, and maintenance of the phenotypic expression of cultured embryonic osteoblasts. Such a device would permit a systematic investigation of the cellular response to specific, independently controlled parameters of mechanical deformation. Using a prototype device designed to impose a dynamic sinusoidal spatially isotropic biaxial strain profile, we confirmed experimentally that the strain was biaxially uniform and isotropic (radial = circumferential strain over the entire culture membrane) to within 14% (SD/mean) for the range of the peak strains tested (2.3-9.4%). Additionally, the uniformity was maintained at 1 Hz for at least 5 days of continuous operation. This experimental verification of the theoretically predicted isotropic strain profile suggests that the design principle is sound. Embryonic osteoblasts cultured on the flexible substrate proliferated and exhibited a temporal pattern of phenotypic expression (extracellular matrix accumulation and mineralization) comparable with that observed on polystyrene of tissue culture grade.

Background and Objective Previous studies in laser assisted vascular welding have been limited by the lack of a reliable end point for tissue fusion. As a means of improving the reproductibility of laser assisted repairs, a system incorporating real time temperature monitoring and closed loop feedback was used. Study Design/Materials and Methods The system consisted of a direct view infrared thermometer for monitoring the laser heated spot, a 1.9 μm diode laser, and a microprocessor for data acquisition and feedback control of the laser power to maintain a constant tissue temperature. Rat aortas were welded under constant surface temperature conditions. Results In vivo temperature stability of ±2°C was achieved over a temperature range of 70–90°C pertinent to welding small vessels. When welds were completed using the feedback system to maintain the tissue temperature at 80°C, the acute success rate was 100% and the burst pressure was 290 ± 70 mmHg. Conclusion These studies demonstrate that the use of real time monitoring and feedback control results in improved consistency for vascular tissue welding. © 1996 Wiley‐Liss, Inc.

The VSD makes it possible to approximate, in vitro, those forces encountered by vascular wall cells, in vivo and therefore may make it possible to determine whether specific combinations of mechanical and hemodynamic forces are causally associated with specific vascular diseases.

No abstract