No abstract

Abstract

No abstract

The aim of this study was to clarify the initiation process and the propagation mechanism of positive underwater streamers under the application of pulsed voltage with a duration of 10 μs, focusing on two different theories of electrical discharges in liquids: the bubble theory and the direct ionization theory. The initiation process, which is the time lag from the beginning of voltage application to streamer inception, was found to be related to the bubble theory. In this process, Joule heating resulted in the formation of a bubble cluster at the tip of a needle electrode. Streamer inception was observed from the tip of a protrusion on the surface of this bubble cluster, which acted as a virtual sharp electrode to enhance the local electric field to a level greater than 10 MV/cm. Streak imaging of secondary streamer propagation showed that luminescence preceded gas channel generation, suggesting a mechanism of direct ionization in water. Streak imaging of primary streamer propagation revealed intermittent propagation, synchronized with repetitive pulsed currents. Shadowgraph imaging of streamers synchronized with the light emission signal indicated the possibility of direct ionization in water for primary streamer propagation as well as for secondary streamer propagation.

The present study concerns a temporally evolving turbulent natural convection boundary layer (NCBL) adjacent to an isothermally heated vertical wall, with Prandtl number 0.71. Three-dimensional direct numerical simulations (DNS) are carried out to investigate the turbulent flow up to $\textit {Gr}_\delta =1.21\times 10^8$ , where $\textit {Gr}_\delta$ is the Grashof number based on the boundary layer thickness $\delta$ . In the near-wall region, there exists a constant heat flux layer, similar to previous studies for the spatially developing flows (e.g. George & Capp, Intl J. Heat Mass Transfer, vol. 22, 1979, pp. 813–826). Beyond a wall-normal distance $\delta _i$ , the NCBL can be characterised as a plume-like region. We find that this region is well described by a self-similar integral model with profile coefficients (cf. van Reeuwijk & Craske, J. Fluid Mech., vol. 782, 2015, pp. 333–355) which are $\textit {Gr}_\delta$ -independent after $\textit {Gr}_\delta =10^7$ . In this Grashof number range both the outer plume-like region and the near-wall boundary layer are turbulent, indicating the beginning of the so-called ultimate turbulent regime (Grossmann & Lohse, J. Fluid Mech., vol. 407, 2000, pp. 27–56; Grossmann & Lohse, Phys. Fluids, vol. 23, 2011, 045108). Solutions to the self-similar integral model are analytically obtained by solving ordinary differential equations with profile coefficients empirically obtained from the DNS results. In the present study, we have found the wall heat transfer of the NCBL is directly related to the top-hat scales which characterise the plume-like region. The Nusselt number is found to follow $\textit {Nu}_\delta \propto \textit {Gr}_\delta ^{0.381}$ , slightly higher than the empirical $1/3$ -power-law correlation reported for spatially developing NCBLs at lower $\textit {Gr}_\delta$ , but is shown to be consistent with the ultimate heat transfer regime with a logarithmic correction suggested by Grossmann & Lohse (Phys. Fluids, vol. 23, 2011, 045108). By modelling the near-wall buoyancy force, we show that the wall shear stress would scale with the bulk velocity only at asymptotically large Grashof numbers.

No abstract

No abstract

No abstract