The study aimed at investigating the microstructure and mechanical properties of Neodymium-Doped Yttrium Aluminum Garnet (Nd:YAG) laser welded high strength low alloy (HSLA) SA516 grade 70 boiler steel. The weld joint for a 4 mm thick plate was successfully produced using minimum laser power of 2 kW by employing a single pass without any weld preheat treatment. The micrographs revealed the presence of martensite phase in the weld fusion zone which could be due to faster cooling rate of the laser weldment. A good correlation was found between the microstructural features of the weld joints and their mechanical properties. The highest hardness was found to be in the fusion zone of cap region due to formation of martensite and also enrichment of carbon. The hardness results also showed a narrow soft zone at the heat affected zone (HAZ) adjacent to the weld interface, which has no effect on the weld tensile strength. The yield strength and ultimate tensile strength of the welded joints were 338 MPa and 549 MPa, respectively, which were higher than the candidate metal. These tensile results suggested that the laser welding process had improved the weld strength even without any weld preheat treatment and also the fractography of the tensile fractured samples showed the ductile mode of failure.
The mechanism of austenite reversion in 18 Ni Co‐free maraging steel (250 grade) has been established by conducting extensive X‐ray diffraction (XRD) and transmission electron microscopy (TEM) under differently aged conditions. It has been proposed that contrary to the precipitate dissolution mechanism suggested for the initiation of austenite reversion in 18Ni‐8Co‐5Mo type maraging steels, the initiation of transformation of martensite to austenite in this type of maraging steel is due to the diffusion of Ni from matrix to the dislocations and other defect structures on prolonged/high temperature ageing. This results in local enrichment of Ni which lowers both AS and MS temperatures of the region. Lowering of these transformation temperatures is responsible for the early reversion of martensite to Ni‐enriched stable austenite which, on subsequent cooling to room temperature, does not transform back to martensite.
In this research work, the weldability of low alloyed AISI 4340 aeronautical steel and AISI 304L austenitic stainless steel joined by continuous current (CC) and pulsed current (PC) gas tungsten arc welding (GTAW) techniques, using ER309L and ERNiCr-3 filler metals was investigated. The main focus of the study involves the investigation on the effect of continuous and pulsed current mode of GTA welding process on the metallurgical and mechanical properties of these dissimilar weldments. Microstructure studies revealed the formation of different zones across the weldments, vis-à-vis martensite at the HAZ of AISI 4340, vermicular δ -ferrite /ferrite stringers at the HAZ of AISI 304L, pearlite colonies at the parent metal of AISI 4340 and equi-axed cellular and/or columnar dendrites at the weld zone. Tensile results showed that current pulsing accrued better tensile properties. The structure -property relationships of these weldments were established based on the current modes employed by utilizing combined techniques of optical microscopy, scanning electron microscopy (SEM) and energy dispersive spectroscopy (EDS).
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.