An ordered mesoporous tungsten‐oxide/carbon (denoted as m‐WO3−x‐C‐s) nanocomposite is synthesized using a simple one‐pot method using polystyrene‐block‐poly(ethylene oxide) (PS‐b‐PEO) as a structure‐directing agent. The hydrophilic PEO block interacts with the carbon and tungsten precursors (resol polymer and WCl6), and the PS block is converted to pores after heating at 700 °C under a nitrogen flow. The m‐WO3−x‐C‐s nanocomposite has a high Brunauer–Emmett–Teller (BET) surface area and hexagonally ordered pores. Because of its mesoporous structure and high intrinsic density of tungsten oxide, this material exhibits a high average volumetric capacitance and gravimetric capacitance as a pseudocapacitor electrode. In comparison with reduced mesoporous tungsten oxide (denoted as m‐WO3−x‐h), which is synthesized by a tedious hard template approach and further reduction in a H2/N2 atmosphere, m‐WO3−x‐C‐s shows a high capacitance and enhanced rate performance, as confirmed by cyclic voltammetry, galvanostatic charge/discharge measurements, and electrochemical impedance spectroscopy. The good performance of m‐WO3−x‐C‐s is attributed to the high surface area arising from the mesoporous structure, the large interconnected mesopores, and the low internal resistance from the well‐dispersed reduced tungsten oxide and amorphous carbon composite structure. Here, the amorphous carbon acts as an electrical pathway for effective pseudocapacitor behavior of WO3‐x.

Hydrogen as an energy carrier is very versatile in energy storage applications. Developments in novel, sustainable technologies towards a CO2-free society are needed and the exploration of all-solid-state batteries (ASSBs) as well as solid-state hydrogen storage applications based on metal hydrides can provide solutions for such technologies. However, there are still many technical challenges for both hydrogen storage material and ASSBs related to designing low-cost materials with low-environmental impact. The current materials considered for all-solid-state batteries should have high conductivities for Na+, Mg2+ and Ca2+, while Al3+-based compounds are often marginalised due to the lack of suitable electrode and electrolyte materials. In hydrogen storage materials, the sluggish kinetic behaviour of solid-state hydride materials is one of the key constraints that limit their practical uses. Therefore, it is necessary to overcome the kinetic issues of hydride materials before discussing and considering them on the system level. This review summarizes the achievements of the Marie Skłodowska-Curie Actions (MSCA) innovative training network (ITN) ECOSTORE, the aim of which was the investigation of different aspects of (complex) metal hydride materials. Advances in battery and hydrogen storage materials for the efficient and compact storage of renewable energy production are discussed.