The relation between the nanoscale morphology and associated device properties in conjugated polymer/fullerene bulk‐heterojunction “plastic solar cells” is investigated. We perform complementary measurements on solid‐state blends of poly[2‐methoxy‐5‐(3,7‐dimethyloctyloxy)]‐1,4‐phenylenevinylene (MDMO‐PPV) and the soluble fullerene C60 derivative 1‐(3‐methoxycarbonyl) propyl‐1‐phenyl [6,6]C61 (PCBM), spin‐cast from either toluene or chlorobenzene solutions. The characterization of the nanomorphology is carried out via scanning electron microscopy (SEM) and atomic force microscopy (AFM), while solar‐cell devices were characterized by means of current–voltage (I–V) and spectral photocurrent measurements. In addition, the morphology is manipulated via annealing, to increase the extent of phase separation in the thin‐film blends and to identify the distribution of materials. Photoluminescence measurements confirm the demixing of the materials under thermal treatment. Furthermore the photoluminescence of PCBM clusters with sizes of up to a few hundred nanometers indicates a photocurrent loss in films of the coarser phase‐separated blends cast from toluene. For toluene‐cast films the scale of phase separation depends strongly on the ratio of MDMO‐PPV to PCBM, as well as on the total concentration of the casting solution. Finally we observe small beads of 20–30 nm diameter, attributed to MDMO‐PPV, in blend films cast from both toluene and chlorobenzene.

This paper presents an overview of the research carried out by a European consortium with the aim to develop and test new and improved ways to realise dye-sensitized solar cells (DSC) with enhanced efficiencies and stabilities. Several new areas have been explored in the field of new concepts and materials, fabrication protocols for TiO2 and scatterlayers, metal oxide blocking layers, strategies for co-sensitization and low temperature processes of platinum deposition. Fundamental understanding of the working principles has been gained by means of electrical and optical modelling and advanced characterization techniques. Cost analyses have been made to demonstrate the potential of DSC as a low cost thin film PV technology. The combined efforts have led to maximum non-certified power conversion efficiencies under full sunlight of 11% for areas < 0 center dot 2 cm(2) and 10 center dot 1% for a cell with an active area of 1 center dot 3 cm(2). Lifetime studies revealed negligible device degradation after 1000hrs of accelerated tests under thermal stress at 80 degrees C in the dark and visible light soaking at 60 degrees C. An outlook summarizing future directions in the research and large-scale production of DSC is presented

No abstract

We conducted a comprehensive Kelvin probe force microscopy (KPFM) study on a classical organic solar cell system consisting of MDMO-PPV/PCBM blends. The KPFM method yields the information of topography and local work function at the nanometer scale. Experiments were performed either in the dark or under cw laser illumination at 442 nm. We identified distinct differences in the energetics on the surface of chlorobenzene and toluene cast blend films. Together with high-resolution scanning electron microscopy (SEM) experiments we were able to interpret the KPFM results and to draw some conclusions for the electron transport toward the cathode in the solar cell configuration. The results suggest that surfaces of toluene cast films exhibit a morphologically controlled hindrance for electron propagation toward the cathode, which is usually evaporated on top of the films in the solar cell device configuration.