Li metal batteries suffer from dendrite formation which causes short circuit of the battery. Therefore, it is important to understand the chemical composition and growth mechanism of dendrites that limit battery efficiency and cycle life. In this study, in situ scanning electron microscopy was employed to monitor the cycling behavior of all-solid Li metal batteries with LiFePO4 cathodes. Chemical analyses of the dendrites were conducted using a windowless energy dispersive spectroscopy detector, which showed that the dendrites are not metallic lithium as universally recognized. Our results revealed the carbide nature of the dendrites with a hollow morphology and hardness greater than that of pure lithium. These carbide-based dendrites were able to perforate through the polymer, which was confirmed by milling the polymer using focused ion beam. It was also shown that applying pressure on the battery can suppress growth of the dendrites.

Dendrite formation, which could cause a battery short circuit, occurs in batteries that contain lithium metal anodes. In order to suppress dendrite growth, the use of electrolytes with a high shear modulus is suggested as an ionic conductive separator in batteries. One promising candidate for this application is Li7La3Zr2O12 (LLZO) because it has excellent mechanical properties and chemical stability. In this work, in situ scanning electron microscopy (SEM) technique was employed to monitor the interface behavior between lithium metal and LLZO electrolyte during cycling with pressure. Using the obtained SEM images, videos were created that show the inhomogeneous dissolution and deposition of lithium, which induce dendrite growth. The energy dispersive spectroscopy analyses of dendrites indicate the presence of Li, C, and O elements. Moreover, the cross-section mapping comparison of the LLZO shows the inhomogeneous distribution of La, Zr, and C after cycling that was caused by lithium loss near the Li electrode and possible side reactions. This work demonstrates the morphological and chemical evolution that occurs during cycling in a symmetrical Li–Li cell that contains LLZO. Although the superior mechanical properties of LLZO make it an excellent electrolyte candidate for batteries, the further improvement of the electrochemical stabilization of the garnet–lithium metal interface is suggested.

No abstract

With the advances in characterization techniques, various operando/in-situ methods were applied in studying rechargeable batteries in order to improve the electrochemical properties of electrode materials, prolonging the battery life and developing new battery materials. In the present review, we focus on the characterization of electrode materials with operando/in-situ X-ray diffraction and Raman spectroscopies. By correlating the results obtained via these two techniques in different electrode chemistry: (a) intercalation materials, such as layered metal oxides and (b) conversion materials, such as elemental sulfur. We demonstrate the importance of using operando/in-situ techniques in examining the microstructural changes of the electrodes under various operating conditions, in both macro and micro-scales. These techniques also reveal the working and the degradation mechanisms of the electrodes and the possible side reactions involved. The comprehension of these mechanisms is fundamental for ameliorating the electrode materials, enhancing the battery performance and lengthening its cycling life.Keywords: operando/in-situ XRD, operando/in-situ Raman, lithium-sulfur, layered metal oxide, LiFePO 4 , spinel oxide Frontiers in Energy Research | www.frontiersin.org

The thickness of solid‐state electrolytes (SSEs) significantly affects the energy density and safety performance of all‐solid‐state lithium batteries. However, a sufficient understanding of the reactivity toward lithium metal of ultrathin SSEs (<100 µm) based on NASICON remains lacking. Herein, for the first time, a self‐standing and ultrathin (70 µm) NASICON‐type Li1.5Al0.5Ge1.5(PO4)3 (LAGP) electrolyte via a scalable solution process is developed, and X‐ray photoelectron spectroscopy reveals that changes in LAGP at the metastable Li–LAGP interface during battery operation is temperature dependent. Severe germanium reduction and decrease in LAGP particle size are detected at the Li–LAGP interface at elevated temperature. Oriented plating of lithium metal on its preferred (110) face occurs during in situ X‐ray diffraction cycling.