Behaviour of precast-prestressed hollow core slabs has been extensively studied when these slabs are subjected to positive bending moments, a practical application typical of hollow core slabs. However, in many projects it may be required to have an overhanging part of the roof to act as a cantilever. In doing so, and using precast-prestressed hollow core slabs, the slabs would be subjected to negative moments, atypical for hollow core slabs. In this paper, the behaviour of precast-prestressed hollow core slabs is experimentally investigated when they are subjected to negative bending moments. A proposed strengthening detail to increase the negative moment resistance of hollow core slabs using bonded carbon fibre reinforced polymer (CFRP) strips is presented. The CFRP strips were bonded to the top side of full-scale precast-prestressed hollow core slabs in the negative moment zone in different configurations. In two of the tested slabs the bond between the prestressing strands and the concrete was initially broken (during casting of the slabs) in the negative moment zone. The slabs with the bonded CFRP strips were tested to failure and the load–deflection behaviour was recorded. The results of the tests are presented and the strength enhancement of the hollow core slabs using the proposed technique is reported. The increase in the negative moment resistance of the CFRP-bonded hollow core slabs experimentally determined is also compared with the CSA-S806-02 prediction for the moment resistance of concrete elements with bonded CFRP strips.Key words: carbon fibre reinforced polymer (CFRP) strips, hollow core slab, flexure strengthening, prestressed concrete, precast slabs, prestressing strands.
This paper investigates the behavior of confined masonry walls subjected to lateral loads. Six full-scale wall assembles, consisting of a clay masonry panel, two confining columns and a tie beam, were tested under a combination of vertical load and monotonic pushover up to failure. Wall panels had various configurations, namely, solid and perforated walls with window and door openings, variable longitudinal and transverse reinforcement ratios for the confining elements and different brick types, namely, cored clay and solid concrete masonry units. Key experimental results showed that the walls in general experienced a shear failure at the end of the lightly reinforced confining elements after the failure of the diagonal struts formed in the brick wall due to transversal diagonal tension. Stepped bed joint cracks formed in the masonry panel either diagonally or around the perforations. A numerical model was built using the finite element method and was validated in light of the experimental results. The model showed acceptable correlation and was used to conduct a thorough parametric study on various design configurations. The conducted parametric study involved the assessment of the load/displacement response for walls with different aspect ratios, axial load ratios, number of confining elements as well as the size and orientation of perforations. It was found that the strength of the bricks and the number of confining elements play a significant role in increasing the walls' ultimate resistance and displacement ductility. ª 2014 Production and hosting by Elsevier B.V. on behalf of Housing and Building National Research Center.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.