Photovoltaic conversion was achieved from high-density p-n heterojunctions between single-wall carbon nanotubes (SWNTs) and n-type crystalline silicon produced with a simple airbrushing technique. The semitransparent SWNT network coating on n-type silicon substrate forms p-n heterojunctions and exhibits rectifying behavior. Under illumination the numerous heterojunctions formed between substrate generate electron-hole pairs, which are then split and transported through SWNTs (holes) and n-Si (electrons), respectively. The nanotubes serve as both photogeneration sites and a charge carriers collecting and transport layer. Chemical modification by thionyl chloride of the SWNT coating films was found to significantly increase the conversion efficiency by more than 50% through adjusting the Fermi level and increasing the carrier concentration and mobility. Initial tests have shown a power conversion efficiency of above 4%, proving that SOCl(2) treated-SWNT/n-Si configuration is suitable for light-harvesting at relatively low cost.

As electrically conductive and optically transparent thin coating material, double-wall carbon nanotube network was found to have better transparency-conductance performance as compared with single-wall carbon nanotube (SWNT) and multiwall carbon nanotube (MWNT). The electronic transportability and optical properties of the SWNT films can be altered by chemical modification of thionyl chloride. Additionally, the conductance-temperature dependence analysis revealed that variable-range hopping mechanism dominates the conductance of few wall nanotube mats while fluctuation-assisted tunneling plays a more important role in that of MWNT films.

We report solar cells based on high-density p-n heterojunctions between single wall carbon nanotubes (SWCNTs) and a n-type silicon wafer. Chemical modification by thionyl chloride of the SWCNT coating films was found to significantly increase the conversion efficiency by more than 45% through adjusting the Fermi level and increasing the carrier concentration and mobility. Electron-hole pairs are optically excited in the numerous heterojunctions formed between SOCl2-treated SWCNTs thin coating and n-type silicon substrate, and then split and transported through SWCNTs (holes) and n-Si (electrons), respectively.

We compared conductive transparent carbon nanotube coatings on glass substrates made of differently produced single-wall (SWNT), double-wall, and multiwall carbon nanotubes. The airbrushing approach and the vacuum filtration method were utilized for the fabrication of carbon nanotube films. The optoelectronic performance of the carbon nanotube film was found to strongly depend on many effects including the ratio of metallic-to-semiconducting tubes, dispersion, length, diameter, chirality, wall number, structural defects, and the properties of substrates. The electronic transportability and optical properties of the SWNT network can be significantly altered by chemical doping with thionyl chloride. Hall effect measurements revealed that all of these thin carbon nanotube films are of p-type probably due to the acid reflux-based purification and atmospheric impurities. The competition between variable-range hoping and fluctuation-assisted tunneling in the functionized carbon nanotube system could lead to a crossover behavior in the temperature dependence of the network resistance.

In this work, we report a low-cost facile method for the production of few-layer graphene sheets in large quantities through radio-frequency chemical vapor deposition.