No abstract

The aim of this paper is to review the present status of novel MRI techniques as a new important instrument for functional ventilation imaging. The current status and future perspectives in research and clinical applications are summarized. Morphological lung imaging is based on chest radiography and computed tomography, whereas scintigraphy is used for ventilation imaging. During recent years, MRI has emerged as a new means for functional imaging of ventilation. Aerosolized contrast agents and oxygen are used in proton imaging, whereas non-proton imaging relies on fluorine compounds, such as sulfur hexafluoride and perfluorcarbons, or on hyperpolarized noble gases, such as helium-3 or xenon-129. All the gases are administered as inhaled "contrast agents" for imaging of the airways and airspaces. In general, straightforward images demonstrate the homogeneity of ventilation in a breath-hold and allow for determination of ventilated lung. The different properties of the different compounds enable the measurement of additional functional parameters. They comprise airspace size, regional oxygen partial pressure, and analysis of ventilation distribution, ventilation/perfusion ratios, and gas exchange, including oxygen uptake. Novel MRI techniques provide the potential for functional imaging of ventilation. The next steps include definition of the value and the potential of the different contrast mechanisms as well as determination of the significance of the functional information with regard to physiological research and patient management in chronic obstructive pulmonary disease and others.

Purpose:To elucidate the ability of 3 He-MRI to detect ventilation defects in lung transplant recipients, 3 He-MRI was compared to CT for concordance. Materials and Methods:We examined 14 lung recipients using 3 He-MRI on a 1.5 T MR scanner. CT served as a reference method. Up to four representative ventilation defects were defined for each lung on 3 He-MRI and compared to corresponding areas on CT.Results: Altogether, 59 representative ventilation defects were defined on 3 He-MRI. Plausible CT correlates were found for 29 ventilation defects; less plausible CT correlates were found for eight defects. In 22 defects (37%) no corresponding CT changes were detected. CT demonstrated correlates for ventilation defects seen on 3 He-MRI in only 63% of the cases. Conclusion:3 He-MRI yields a clear increase in the number of detected ventilation defects compared to CT. This may have an important impact on the early detection of bronchiolitis obliterans in lung transplant recipients.

A new microfluidic valve or a "v-type valve" which can be flexibly actuated to focus a fluid flow and block a specific area of a microchannel is demonstrated. Valves with different design parameters were fabricated by multilayer soft lithography and characterized at various operating pressures. To evaluate the functionality of the valve, single microparticles (∅ 7 μm and ∅ 15 μm) and single cells were trapped from flowing suspensions. Continuous processes of particle capture and release were achieved by controlling the actuation and deactuation of the valve. Integration of the v-type valve with poly(dimethyl siloxane) (PDMS) monolithic valves in microfluidic devices was demonstrated to illustrate the potential of the system in various applications such as the creation of a solid phase column, the isolation of a specific number of particles in reactors, and the capture and release of particles or cells in the flow of two immiscible liquids. We believe that this new valve system will be suitable for manipulating particles and cells in a broad range of applications.