In this study, mechanical, visual, and microstructure changes of geopolymer concrete exposed to sulfate and salt effects were investigated. Elazı g ferrochrome slag (EFS) and blast furnace slag (BFS)-based geopolymer concretes which completed curing time were immersed in 5% sodium sulfate (Na 2 SO 4 ), magnesium sulfate (MgSO 4 ), sodium chloride (NaCl), and magnesium chloride (MgCl 2 ) solutions for 12 weeks. The compressive strength values, ultrasonic pulse velocities, visual inspections, weight, and length changes of the samples were determined in this investigation. In addition, scanning electron microscopy was performed for the microstructure analysis of the samples removed from the solutions. Sulfate solutions had a more negative effect on the samples than salt solutions. As the EFS ratio in the mixture increases, the loss rate in the strength of the samples exposed to sulfate and salt solutions decreased. While samples exposed to sodium chloride, sodium sulfate, and magnesium sulfate solutions occurred weight gain, samples exposed to magnesium chloride occurred weight loss. The samples in salt solutions shrank, while the samples in sulfate solutions expanded. No deterioration occurred on the surfaces of the samples exposed to the solutions for 12 weeks. K E Y W O R D S blast furnace slag, chemical resistance, ferrochrome slag, geopolymer concrete, salt effect, sulfate effect
Ferrochrome slag (FS) and ground granulated blast furnace slag (GGBFS) were used as resource material in geopolymer concrete mixtures. A mixture of 10 M sodium hydroxide (NaOH) and sodium silicate (Na2SiO3) was used as the activator. After the two different slag‐based geopolymer concrete (SGC) mixtures were prepared and molded. They were kept at 80°C for 24 hr, and then the SGC samples were cured in 23 ± 1°C water for 27 days. Samples that completed the curing times were exposed to the 300 freeze–thaw (F–T) cycles. The compressive strength, ultrasonic pulse velocity, relative dynamic elasticity modulus values, weight changes, and appearances of the SGC samples were examined at the end of every 50 F–T cycles. Scanning electron microscopy analysis was performed to examine the microstructure changes of the samples after 300 F–T cycles. As the GGBFS proportion in the SGC mix increased, the mechanical properties of the samples against the F–T effect increased. Samples containing 100% FS and 75% FS fell apart at the end of 150 and 200 F–T cycles, respectively. The deterioration of the geopolymer gel structures of the samples exposed to F–T was decreased with increasing GGBFS ratio in the mix.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.