-Wind energy conversion systems (WECS) which consist of wind turbines with permanent magnet synchronous generator (PMSG) and full-power converters have become widespread in the field of renewable power systems. Generally, conventional diode bridge rectifiers have used to obtain a constant DC bus voltage from output of PMSG based wind generator. In recent years, together advanced power electronics technology, Pulse Width Modulation (PWM) rectifiers have used in WECS. PWM rectifiers are used in many applications thanks to their characteristics such as high power factor and low harmonic distortion. In general, L, LC and LCL-type filter configurations are used in these rectifiers. These filter configurations are not exactly compensate current and voltage harmonics. This study proposes a hybrid passive filter configuration for PWM rectifiers instead of existing filters. The performance of hybrid passive filter was tested via MATLAB/Simulink environment under various operational conditions and was compared with LCL filter structure. In addition, neuro-fuzzy controller (NFC) was preferred to increase the performance of PWM rectifier in DC bus voltage control against disturbances because of its robust and nonlinear structure. The study demonstrates that the hybrid passive filter configuration proposed in this study successfully compensates current and voltage harmonics, and improves total harmonic distortion and true power factor.

The major drawback of photovoltaic (PV) systems is their dependence on environmental conditions, such as solar radiation and temperature. Because of this dependency, maximum power point tracking (MPPT) control methods are used in PV systems in order to extract maximum power from the PV panels. This study proposes a controller with a hybrid structure based on angle of incremental conductance (AIC) method and Interval Type-2 Takagi Sugeno Kang fuzzy logic controller (IT2-TSK-FLC) for MPPT. MPPT performance of proposed hybrid controller is evaluated via detailed simulation studies and dSPACE-based experimental study. The results validate that the proposed hybrid controller offers fast-tracking speed, high stability, and robust performance against uncertainties arising from disturbance to inputs of the PV system.

In recent years, electronic power transformer (EPT), which is also called solid state transformer, has attracted great interest and has been used in place of the conventional power transformers. These transformers have many important functions as high unity power factor, low harmonic distortion, constant DC bus voltage, regulated output voltage and compensation capability. In this study, proposed EPT structure contains a three-phase pulse width modulation rectifier that converts 800 Vrms AC to 2000 V DC bus at input stage, a dual active bridge converter that provides 400 V DC bus with 5:1 high frequency transformer at isolation stage and a three-phase two level inverter that is used to obtain AC output at output stage. In order to enhance dynamic performance of EPT structure, neuro fuzzy controllers which have durable and nonlinear nature are used in input and isolation stages instead of PI controllers. The main aim of EPT structure with the proposed controller is to improve the stability of power system and to provide faster response against disturbances. Moreover, a number of simulation results are carried out to verify EPT structure designed in MATLAB/Simulink environment and to analyze compensation ability for voltage harmonics, voltage flicker and voltage sag/swell conditions.

It is well-known that rectifiers are used widely in many applications required AC/DC transformation. With technological advances, many studies are performed for AC/DC converters and many control methods are proposed in order to improve the performance of these rectifiers in recent years. Pulse width modulation (PWM) based rectifiers are one of the most popular rectifier types. PWM rectifiers have lower input current harmonics and higher power factor compared to classical diode and thyristor rectifiers. In this study, neuro-fuzzy controller (NFC) which has robust, nonlinear structure and do not require the mathematical model of the system to be controlled has been proposed for PWM rectifiers. Three NFCs are used in control scheme of proposed PWM rectifier in order to control the dq-axis currents and DC voltage of PWM rectifier. Moreover, simulation studies are carried out to demonstrate the performance of the proposed control scheme at MATLAB/Simulink environment in terms of rise time, settling time, overshoot, power factor, total harmonic distortion and power quality.

Wind power can bring new challenges when it is connected to the power grid. Generated power from wind energy system is always fluctuating due to the fluctuations in the wind. This paper shows a study on Power Quality (PQ) analysis of wind turbines installed in Hatay region and has been working for three years. Power quality parameters such as voltage, current, active, reactive and apparent power and harmonics are measured, analyzed and evaluated taking into consideration IEEE 519-1992 standards. These parameters are continuously measured for three months. The recorded parameters are voltage and current rms values of all single phase for every 10 power frequency cycles, average values of current and voltage harmonics every 3 sec, active, reactive, and apparent power values and the power factor every second.

During the last decades, thanks to supportive policies of countries and a decrease in installation costs, total installed capacity of wind power has increased rapidly all around the world. The uncertain and variable nature of wind power has been a problem for transmission system operators and wind power plant owners. To solve this problem, numerous wind power forecast systems have been developed. Unfortunately none of them can obtain absolutely accurate forecasts yet. Thus, researchers assumed that wind power generation is a stochastic process and they proposed a stochastic programming approach to solve problems arising from the uncertainty of wind power. It is well known that representing stochastic process by possible scenarios is a major issue in the stochastic programming approach. Large numbers of scenarios can represent a stochastic process accurately, but it is not easy to solve a stochastic problem that contains a large number of scenarios. For this reason scenario reduction methods have been introduced. Finally, the quality of this reduced scenario set must be at an acceptable level to use them in calculations. All of these reasons have encouraged authors to develop a wind power scenario tool that can generate and reduce the scenario set and test the quality of it. The developed tool uses historical data to model wind forecast errors. Scenarios are generated around 24 day-ahead point wind power forecasts. A fast forward reduction algorithm is used to reduce the scenario set. Two metrics are proposed to assess the quality of the reduced scenario set. Site measurements are used to test the developed wind power scenario tool. Results showed that the tool can generate and reduce the scenario set successfully and the proposed metrics are useful to assess the quality.

No abstract

Buck type DC-DC converter circuit topology is non-linear due to their switched circuit structure. Conventional control systems are insufficient to control non-linear systems. Neural Networks have important abilities such as learning, optimizing and adaptability. Fuzzy logic and neural networks are used as an adaptive structure based on the fuzzy logic controller. This adaptive structure adjusts the properties of the fuzzy rules and the characteristics of the control system so that the Neuro-Fuzzy controller can be adapted to all different system conditions. In this study, experimental studies were carried out on the dSPACE experiment platform to show the dynamic performance of the Neuro-Fuzzy controller, fuzzy logic controller and the conventional PI controller in different system conditions (such as reference voltage tracking and output load change) of buck type DC-DC converter.