Abstract. This paper introduces new insights into the hydrochemical functioning of lowland river systems using fieldbased spectrophotometric and electrode technologies. The streamwater concentrations of nitrogen species and phosphorus fractions were measured at hourly intervals on a continuous basis at two contrasting sites on tributaries of the River Thames -one draining a rural catchment, the River Enborne, and one draining a more urban system, The Cut. The measurements complement those from an existing network of multi-parameter water quality sondes maintained across the Thames catchment and weekly monitoring based on grab samples. The results of the sub-daily monitoring show that streamwater phosphorus concentrations display highly complex dynamics under storm conditions dependent on the antecedent catchment wetness, and that diurnal phosphorus and nitrogen cycles occur under low flow conditions. The diurnal patterns highlight the dominance of sewage inputs in controlling the streamwater phosphorus and nitrogen concentrations at low flows, even at a distance of 7 km from the nearest sewage treatment works in the rural River Enborne. The time of sample collection is important when judging water quality against ecological thresholds or standards. An exhaustion of the supply of phosphorus from diffuse and multiple septic tank sources during storm events was evident and load estimation was not improved by sub-daily monitoring beyond that achieved by daily sampling because of the eventual reduction in the phosphorus mass entering the stream during events. The results highlight the utility of sub-daily water quality measurements and the discussion considers the practicalities and challenges of in situ, sub-daily monitoring.

The prime objective of this research study was the investigation the new natural cellulosic fiber extracted from the stem of Abutilon Indicum plants as an alternative reinforcement in greener composite materials for structural applications. Abutilon Indicum a flowering plant with unique medicinal values are abundantly found in India and other south Asian countries. The fibers extracted from the stem of the Abutilon Indicum plant are proven to be sustainable, ecofriendly, and novel and hence this fiber is chosen for characterization study. In this experimental investigation the physical, chemical, thermal, morphological, crystallinity, chemical constituents, and surface characteristics of raw Abutilon Indicum fibers (AIF) were analyzed. Chemical analysis results convey the presence of higher cellulose content of (56.12 wt.%) in AIF. The diameter (175 μm) and density (1.170 g/cm3) of AIFs are determined by physical analysis of the raw fibers. Such lower density values observed in AIF make it as a perfect material for lightweight applications. Crystalline properties of AIFs are determined from X‐ray diffraction tests with a crystalline index of 77.35%, and crystalline size of 2.20 nm, which attributes to the presence of cellulose‐1β and the crystallites are ordered in nature. Thermal stability of 175°C, maximum degradation temperature upto 302.6°C and kinetic activation energy of 86.95 kJ/mol of AIF are established based on thermo gravimetric analysis. Morphological and surface characteristics of AIF through a scanning electron microscope (SEM) and atomic force microscope (AFM) analysis revealed that the raw fibers display a relatively finer surface. Research findings of the AIF mentioned above conclude that the AIFs prove to be an ideal, alternative reinforcement in greener composite materials for sustainable and cleaner production of components in structural applications.

Present study was conducted to investigate the adsorption and ultrasound-assisted adsorption potential of silver nanoparticles (AgNPs) and silver nanoparticles loaded on chitosan (AgCS composite) as nano-adsorbents for methylene blue (MB) removal. AgNPs were synthesized using leaf extract of Ligustrum lucidum, which were incorporated on the chitosan’s surface for modification. UV–Vis Spectroscopy, FTIR, XRD, SEM, and EDX techniques were used to confirm the synthesis and characterization of nanomaterials. Batch adsorption and sono-adsorption experiments for the removal of MB were executed under optimal conditions; for fitting the experimental equilibrium data, Langmuir and Freundlich’s isotherm models were adopted. In addition, the antimicrobial potential of the AgNPs and AgCS were examined against selected bacterial and fungal strains. UV–Vis spectroscopy confirmed AgNPs synthesis from the leaf extract of L. lucidum used as a reducer, which was spherical as exposed in the SEM analysis. The FTIR spectrum illustrated phytochemicals in the leaf extract of L. lucidum functioning as stabilizing agents around AgNPs and AgCS. Whereas, corresponding crystalline peaks of nanomaterial, including a signal peak at 3 keV indicating the presence of silver, were confirmed by XRD and EDX. The Langmuir model was chosen as an efficient model for adsorption and sono-adsorption, which exposed that under optimum conditions (pH = 6, dye initial concentration = 5 mg L−1, adsorbents dosage = 0.005 g, time = 120 min, US power 80 W), MB removal efficiency of AgNPs was >70%, using ultrasound-assisted adsorption compared to the non-sonicated adsorption. Furthermore, AgNPs exhibited promising antibacterial potential against Staphylococcus aureus with the maximum zone of inhibition (14.67 ± 0.47 mm). It was concluded that the green synthesis approach for the large-scale production of metallic nanoparticles is quite effective and can be recommended for efficient and cost-effective way to eradicate dyes, particularly from textile wastewater

The worldwide spread and increasing prevalence of carbapenem-resistant Enterobacteriaceae (CRE) is of utmost concern and a problem for public health. This resistance is mainly conferred by carbapenemase production. Such strains are a potential source of outbreaks in healthcare settings and are associated with high rates of morbidity and mortality. In this study, we aimed to determine the dominance of NDM-producing Enterobacteriaceae at a teaching hospital in Karachi. A total of 238 Enterobacteriaceae isolates were collected from patients admitted to Jinnah Postgraduate Medical Centre (Unit 4) in Karachi, Pakistan, a tertiary care hospital. Phenotypic and genotypic methods were used for detection of metallo-β-lactamase. Out of 238 isolates, 52 (21.8%) were CRE and 50 isolates were carbapenemase producers, as determined by the CARBA NP test; two isolates were found negative for carbapenemase production by CARB NP and PCR. Four carbapenemase-producing isolates phenotypically appeared negative for metallo-β-lactamase (MBL). Of the 52 CRE isolates, 46 (88.46%) were blaNDM positive. Most of the NDM producers were Klebsiella pneumoniae, followed by Enterobacter cloacae and Escherichia coli. In all the NDM-positive isolates, the blaNDM gene was found on plasmid. These isolates were found negative for the VIM and IPM MBLs. All the CRE and carbapenem-sensitive isolates were sensitive to colistin. It is concluded that the NDM is the main resistance mechanism against carbapenems and is dominant in this region.

No abstract