Biosensor systems for wearable continuous monitoring are desired to be developed into conformal patch platforms. However, developing such patches is very challenging owing to the difficulty of imparting materials and components with both high stretchability and high performance. Herein, we report a fully stretchable microfluidics-integrated glucose sensor patch comprised of an omnidirectionally stretchable nanoporous gold (NPG) electrochemical biosensor and a stretchable passive microfluidic device. A highly electrocatalytic NPG electrode was formed on a stress-absorbing 3D micropatterned polydimethylsiloxane (PDMS) substrate to confer mechanical stretchability, high sensitivity, and durability in non-enzymatic glucose detection. A thin, stretchable, and tough microfluidic device was made by embedding stretchable cotton fabric as a capillary into a thin polyurethane nanofiber-reinforced PDMS channel, enabling collection and passive, accurate delivery of sweat from skin to the electrode surface, with excellent replacement capability. The integrated glucose sensor patch demonstrated excellent ability to continuously and accurately monitor the sweat glucose level.

Stretchable piezoelectric nanogenerators (SPENGs) for human kinematics energy harvesting have limited use due to the low stretchability or mechanical robustness and the difficulty of structural design for omnidirectional stretchability. This study reports an efficient, omnidirectionally stretchable, and robust SPENG based on a stretchable graphite electrode on a 3D micropatterned stretchable substrate and a stacked mat of piezoelectric nanofibers. The stacked mat of free‐standing nanofibers is alternatively composed of nanocomposite nanofibers of barium titanate nanoparticles embedded in polyurethane and poly(vinylidene fluoride‐trifluoroethylene) nanofibers. The nanofiber SPENG (nf‐SPENG) exhibits a high stretchability of 40% and high mechanical durability up to 9000 stretching cycles at 30% strain, which are attributed to the stress‐relieving nature of the 3D micropattern on the substrate and the free‐standing stacked hybrid nanofibers. The nf‐SPENG produces a peak open circuit voltage (Voc) and short circuit current (Isc) of 9.3 V and 189 nA, respectively. The nf‐SPENG is demonstrated to harvest the energy from human kinematics while walking when placed over the knee cap of a subject, generating a maximum Voc of 10.1 V. The omnidirectional stretchability, efficiency, facile fabrication process, mechanical durability, environmentally friendly lead‐free components, and response to multimodal straining make this device suitable for self‐powered wearable sensing systems.

No abstract

A Schottky diode based on a heterojunction of three-dimensional (3D) nanohybrid materials, formed by hybridizing reduced graphene oxide (RGO) with epitaxial vertical zinc oxide nanorods (ZnO NRs) and AlGaN(∼25 nm)/GaN is presented as a new class of high-performance chemical sensors. The RGO nanosheet layer coated on the ZnO NRs enables the formation of a direct Schottky contact with the AlGaN layer. The sensing results of the Schottky diode with respect to NO, SO, and HCHO gases exhibit high sensitivity (0.88-1.88 ppm), fast response (∼2 min), and good reproducibility down to 120 ppb concentration levels at room temperature. The sensing mechanism of the Schottky diode can be explained by the effective modulation of the reverse saturation current due to the change in thermionic emission carrier transport caused by ultrasensitive changes in the Schottky barrier of a van der Waals heterostructure between RGO and AlGaN layers upon interaction with gas molecules. Advances in the design of a Schottky diode gas sensor based on the heterojunction of high-mobility two-dimensional electron gas channel and highly responsive 3D-engineered sensing nanomaterials have potential not only for the enhancement of sensitivity and selectivity but also for improving operation capability at room temperature.

Human skin is highly stretchable at low strain but becomes self-limiting when deformed at large strain due to stiffening caused by alignment of a network of stiff collagen nanofibers inside the tissue beneath the epidermis. To imitate this mechanical behavior and the sensory function of human skin, we fabricated a skin-like substrate with highly stretchable, transparent, tough, ultrathin, mechanosensory, and self-limiting properties by incorporating piezoelectric crystalline poly((vinylidene fluoride)- co-trifluoroethylene) (P(VDF-TrFE)) nanofibers with a high modulus into the low modulus matrix of elastomeric poly(dimethylsiloxane). Randomly distributed P(VDF-TrFE) nanofibers in the elastomer matrix conferred a self-limiting property to the skin-like substrate so that it can easily stretch at low strain but swiftly counteract rupturing in response to stretching. The stretchability, toughness, and Young's modulus of the ultrathin (∼62 μm) skin-like substrate with high optical transparency could be tuned by controlling the loading of nanofibers. Moreover, the ultrathin skin-like substrate with a stretchable temperature sensor fabricated on it demonstrated the ability to accommodate bodily motion-induced strain in the sensor while maintaining its mechanosensory and thermosensory functionalities.