Nanosilver-modified TiO2 and ZnO photocatalysts were studied against methicillin-resistant Staphylococcus aureus on the surface and against naturally occurring airborne microorganisms. The photocatalysts/polymer nanohybrid films were prepared by spray coating technique on the surface of glass plates and on the inner surface of the reactive light source. The photoreactive surfaces were activated with visible light emitting LED light at λ = 405 nm. The optical properties of the prepared photocatalyst/polymer nanohybrid films were characterized by diffuse reflectance measurements. The photocatalytic properties were verified with the degradation of ethanol by gas chromatography measurements. The destruction of the bacterial cell wall component was examined with transmission electron microscope. The antibacterial effect of the photocatalyst/polymer nanohybrid films was tested with different methods and with the associated standard ISO 27447:2009. With the photoreactive coatings, an extensive disinfectant film was developed and successfully prepared. The cell wall component of S. aureus was degraded after 1 h of illumination. The antibacterial effect of the nanohybrid films has been proven by measuring the decrease of the number of methicillin-resistant S. aureus on the surface and in the air as the function of illumination time. The photocatalyst/polymer nanohybrid films could inactivate 99.9 % of the investigated bacteria on different thin films after 2 h of illumination with visible light source. The reactive light source with the inner-coated photocatalyst could kill 96 % of naturally occurring airborne microorganisms after 48 h of visible light illumination in indoor air sample. The TEM results and the microbiological measurements were completed with toxicity tests carried out with Vibrio fischeri bioluminescence bacterium.
The aim of this study was to develop photoreactive surface coatings, possessing antibacterial proper ties and can be activated under visible light illumination (%max=405nm) using LED-light source. The photocatalytically active titanium dioxide (TiO2) was functionalized with silver nanoparticles (Ag NPs) and immobilized in polyacrylate based nanohybrid thin film in order to facilitate visible light activity (-^Ag/TiO2,maX = 500 nm). First, the photocatalytic activity was modelled by following ethanol vapor degra dation. The plasmonic functionalization resulted in 15% enhancement of the activity compared to pure TiO2. The photoreactive antimicrobial (5log reduction of cfu in 2h) surface coatings are able to inac tivate clinically relevant pathogen strains (methicillin resistant Staphylococcus aureus, Escherichia coli, Pseudomonas aeruginosa) within short time (60-120 min) due to the formed and quantified reactive oxy gen species (ROS). The existence of electrostatic interactions between the negatively charged bacteria (from-0.89 to-3.19 ^eq/109 cfu) and positively charged photocatalyst particles (in the range of +0.38 and +12.3meq/100g) was also proven by charge titration measurements. The surface inactivation of the bacteria and the photocatalytic degradation of the cell wall component were also confirmed by fluo rescence and transmission electron microscopic observations, respectively. According to the results an effective sterilizing system and prevention strategy can be developed and carried out against dangerous microorganisms in health care.
The pH-responsive intelligent drug release facility of hydrophobically modified chitosan nanoparticles (Chit NPs) (d = 5.2 ± 1.1 nm) was presented in the case of poorly water soluble Ca channel blocker nimodipine (NIMO) drug molecules. The adequate pH-sensitivity, i.e. the suitable drug carrier properties of the initial hydrophilic Chit were achieved by reductive amination of Chit with hexanal (C-) and dodecanal (C-) aldehydes. The successful modifications of the macromolecule were evidenced via FTIR measurements: the band appearing at 1412 cm (CN stretching in aliphatic amines) in the cases of the hydrophobically modified Chit samples shows that the CN bond successfully formed between the Chit and the aldehydes. Hydrophobization of the polymer unambiguously led to lower water contents with lower intermolecular interactions in the prepared hydrogel matrix: the initial hydrophilic Chit has the highest water content (78.6 wt%) and the increasing hydrophobicity of the polymer resulted in decreasing water content (C-chit.: 74.2 wt% and C-chit.: 47.1 wt%). Furthermore, it was established that the length of the side chain of the aldehyde influences the pH-dependent solubility properties of the Chit. Transparent homogenous polymer solution was obtained at lower pH, while at higher pH the formation of polymer (nano)particles was determined and the corresponding cut-off pH values showed decreasing tendency with increasing hydrophobic feature (pH = 7.47, 6.73 and 2.49 for initial Chit, C-chit and C-chit, respectively). Next the poorly water soluble NIMO drug was encapsulated with the C-chit with adequate pH-sensitive properties. The polymer-stabilized NIMO particles with 10 wt% NIMO content resulted in stable dispersion in aqueous phase, the formation of polymer shell increased in the water solubility/dispersibility of the initial hydrophobic drug. According to the drug release experiments, we clearly confirmed that the encapsulated low crystallinity NIMO drug remained closed in the polymer NPs at normal tissue pH (pH = 7.4, PBS buffer, physiological condition) but at pH < 6.5 which is typical for seriously ischemic brain tissue, 93.6% of the available 0.14 mg/ml NIMO was released into the buffer solution under 8 h release time. According to this in vitro study, the presented pH-sensitive drug carrier system could be useful to selectively target ischemic brain regions characterized by acidosis, to achieve neuroprotection at tissue zones at risk of injury, without any undesirable side effects caused by systemic drug administration.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.