Manufacturing tolerances for laminar flow wings can be significantly tighter than those of conventional aircraft. The tighter tolerances can significantly affect the assessment of the practicality of designing for laminar flow. However, existing data on the effects of excrescences typical of manufacturing process are limited. Further, information on the effects-often beneficial-of pressure gradient present on the laminar flow wings is not generally available. To address these concerns, a series of experiments has been undertaken to examine the effects of surface steps in the presence of pressure gradients. The step geometries were selected to represent those that result from actual aircraft manufacturing processes. The range of pressure gradients correspond to those typical of laminar flow wings. Initial experiments were conducted in a low-speed wind tunnel. Later experiments used a novel propelled-model test facility. The results of these studies show that the allowable sizes of surface excrescences for laminar flow wings may be significantly greater than has conventionally been assumed. This could significantly influence the more widespread use of laminar flow for drag reduction, resulting in more efficient aircraft.
To conserve power while ensuring good performance on resourceconstrained mobile devices, devices transition between different Radio Resource Control (RRC) states in response to network traffic and according to parameters specific to network operators. As RRC states significantly affect application power consumption and performance, it is important to understand how RRC state timers interact with network traffic patterns. In this paper, we show that the impact of RRC states on performance is significantly more complex and diverse than found in previous work. To do so, we introduce an open-source tool that allows the impact of RRC states on network and application performance to be measured in a robust and accurate manner on unmodified user devices, and deploy the tool in 23 countries around the world to test a broad range of cellular network technologies. We detect previously unknown performance problems which increase network latencies by up to several seconds and for LTE, can increase packet losses by an order of magnitude. Through an in-depth cross-layer analysis of several carriers, we examine the lower-layer causes of these problems. We determine that the highly complex state transitions of certain carriers, and in particular poor interactions between state demotions and network traffic, can lead to substantial, unexpected latencies.
Skin-friction measurements were obtained on two laminar flow airfoils in the NASA Ames 11-ft transonic wind tunnel using oil-film interferometry. Improvements in the experimental technique allowed skin-friction measurements at two conditions per run in conjunction with performance testing, thus reducing the impact on the run schedule. Quantitative measurements of skin friction were used to determine transition location and the extent of separation (if any) on the airfoils providing much more insight into the flow than flow viz. The technique has been extended to obtain a quantitative measure of shear in the reversed flow region. The effects of various disturbances to the boundary layer were also investigated. Laminar flow was found as far back as 60% chord at a Reynolds number of 4:5 10 6 .
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.