Calibration of flow cytometers is becoming an increasingly important issue for both quality control of instrument performance and quantitation of antibody binding capacity of cells. Due to the numerous different instruments and analysis software currently available, a standardized method of calibration is necessary if interlaboratory comparison of instrument performance and antibody binding is to be achieved. This report describes a new methodology to obtain a standard calibration plot that can be derived from all instruments and from which specific instrument‐independent performance parameters may be calculated that can be used to directly compare the performance and setup of these instruments. The requirements that the calibrated standards must meet are discussed, as well as the acceptable ranges proposed for the instrument‐independent performance parameters. In addition, data are presented from standard calibration plots generated by different flow cytometers in numerous laboratories. The corresponding Primary Performance Parameters calculated from these plots are presented and compared. It is expected that the use of this calibration method may help standardize flow cytometric measurements and will provide instrument‐independent performance parameters to monitor quality control of instruments and reagents. © 1996 Wiley‐Liss, Inc.

No abstract

The quantitation of fluorescence radiance may at first suggest the need to obtain the number of fluorophore that are responsible for the measured fluorescence radiance. This goal is beset by many difficulties since the fluorescence radiance depends on three parameters 1) the probability of absorbing a photon (molar extinction), 2) the number of fluorophores, and 3) the probability of radiative decay of the excited state (quantum yield). If we use the same fluorophore in the reference solution and the analyte then, to a good approximation, the molar extinction drops out from the comparison of fluorescence radiance and we are left with the comparison of fluorescence yield which is defined as the product of fluorophore concentration and the molecular quantum yield. The equality of fluorescence yields from two solutions leads to the notion of equivalent number of fluorophores in the two solutions that is the basis for assignment of MESF (Molecules of Equivalent Soluble Fluorophore) values. We discuss how MESF values are assigned to labeled microbeads and by extension to labeled antibodies, and how these assignments can lead to the estimate of the number of bound antibodies in flow cytometer measurements.

No abstract

Flow cytometers are instruments that can determine multiparameter data simultaneously and have a great potential in providing unique information about cells. To transfer this potential to the clinical laboratory, the development and the proper use of standards and calibrators are required to ensure comparability and reproducibility of data from different flow cytometers. Although there are a number of types of standards for flow cytometry, each has its specifically designed purpose to ensure that data from this complex instrument are accurate, precise, and reproducible among instruments over time.