Thermo-Economic and Heat Transfer Optimization of Working-Fluid Mixtures in a Low-Temperature Organic Rankine Cycle System

Abstract

Abstract:In the present paper, we consider the employment of working-fluid mixtures in organic Rankine cycle (ORC) systems with respect to thermodynamic and heat-transfer performance, component sizing and capital costs. The selected working-fluid mixtures promise reduced exergy losses due to their non-isothermal phase-change behaviour, and thus improved cycle efficiencies and power outputs over their respective pure-fluid components. A multi-objective cost-power optimization of a specific low-temperature ORC system (operating with geothermal water at 98 • C) reveals that the use of working-fluid-mixtures does indeed show a thermodynamic improvement over the pure-fluids. At the same time, heat transfer and cost analyses, however, suggest that it also requires larger evaporators, condensers and expanders; thus, the resulting ORC systems are also associated with higher costs. In particular, 50% n-pentane + 50% n-hexane and 60% R-245fa + 40% R-227ea mixtures lead to the thermodynamically optimal cycles, whereas pure n-pentane and pure R-245fa have lower plant costs, both estimated as having ∼14% lower costs per unit power output compared to the thermodynamically optimal mixtures. These conclusions highlight the importance of using system cost minimization as a design objective for ORC plants.

Hybrid Electric Vehicle Performance with Organic Rankine Cycle Waste Heat Recovery System

“…On the other hand, an electric turbocompound setup can exploit the exhaust gas energy to gain electrical power that can be saved in a battery or used to support several electric components of the vehicle, increasing the fuel economy up to 10%. Currently, approximately a 2% reduction in fuel consumption can be offered by thermoelectric generators, which use the exhaust gas heat to produce electricity directly via thermoelectric conversion means [2,17,20]. This study focuses on the bottoming cycle type of waste heat recovery, which employs thermodynamic cycles to gain energy out of the exhaust gas heat.…”

“…The current trend of the automotive industry focuses not only on maximizing the vehicle's performance, but also in minimizing the emissions and fuel consumption of the vehicle [1,2]. Several technologies have been developed since the 1990s, when worldwide emissions standards started to impose boundaries on the levels of acceptable emissions of vehicles, which resulted in ever-reducing levels of emissions, as well as fuel consumption [3,4].…”

Case Study of an Organic Rankine Cycle (ORC) for Waste Heat Recovery from an Electric Arc Furnace (EAF)

“…ORC systems have the design option of employing a number of organic working fluids, ranging from refrigerants to hydrocarbons and siloxanes [22], including working fluid mixtures [23] in order to optimize the heat transfer (and heat recovery) from/to the waste heat source and heat sink [24]. The use of zeotropic mixtures is of particular interest as it can reduce thermodynamic irreversibility, e.g., in the condenser [25].…”

Small Scale Organic Rankine Cycle (ORC): A Techno-Economic Review

“…The selection of an organic compound with good heat transfer properties would lead to the reduction of the heat transfer surface, which, in turn, lowers the overall size, weight and cost of the ORC system [88].…”