The Fabrication of a Photoresponsive Molecularly Imprinted Polymer for the Photoregulated Uptake and Release of Caffeine

Abstract

A photoresponsive molecularly imprinted polymer (MIP) material is successfully fabricated from an azobenzene‐based functional monomer, 4‐[(4‐methacryloyloxy)phenylazo]benzoic acid (MPABA), using caffeine as a molecular template. The trans–cis photoisomerization properties of MPABA are retained after incorporation into the rigid 3D crosslinked polymer matrix. Substrate affinity of the MIP receptor sites is photoswitchable. This can be attributed to the photoisomerization of azobenzene chromophores within the MIP receptors, resulting in the alteration of their geometry and the spatial arrangement of their binding functionalities. The favorable binding constant of the MIP receptors for caffeine is 5.48 × 104 M–1 in dimethylsulfoxide. The density of the caffeine‐specific receptor sites in the MIP material is 0.95 μmol (g MIP)–1. Upon irradiation at 365 nm, 58.3 % of receptor‐bound caffeine is released from the MIP material. Subsequent irradiation at 440 nm causes 96.4 % of the released caffeine to be rebound by the MIP material. This near‐quantitative uptake of the released caffeine is evidence of the reversibility of the receptor‐site configuration and substrate affinity during the photoswitching of the azobenzene chromophores. Although the photoregulated substrate release and uptake processes are generally repeatable, a gradual reduction in the extent of substrate release and rebinding is observed. This may be caused by the slow deformation of MIP receptors during the course of repetitive photoswitching. The results of this work demonstrate the potential of stimuli‐responsive MIP materials as smart chemicals and as drug‐delivery systems.

Fabrication of Polymer Membrane Enzyme Reactors with a Dual-Responsive Feature for Cascade Enzyme Reaction Regulation

“…In contrast, the UV–vis absorption decreased over time without 365 nm UV light irradiation (Figure B). The change in UV–vis absorption spectra corresponding to P­(S-M-AA-MP) was similar to that of a previous report …”

Photoresponsive Surface Molecularly Imprinted Polymers for the Detection of Profenofos in Tomato and Mangosteen

“…The trans→ cis and cis→ trans photoisomerization rate constants of PS-co-PMAA@PSMIPs were 1.98-and 1.02-fold smaller than those of MPABA. The trend was consistent with previous reports (Gong et al, 2006(Gong et al, , 2016Li et al, 2015). Compared with the trans→ cis photoisomerization rate constant, the possible reason for the smaller decrease in cis→ trans photoisomerization rate constant was that sufficient free volume was created after trans→ cis photoisomerization.…”

A photoswitchable “host-guest” approach for the selective enrichment of dimethoate from olive oil

“…The FTIR spectra are consistent with data reported in the literature [24]. Photo-MIP and Photo-NIP FTIR spectra are shown in the Supplementary Materials section (Fig.…”