The Effect of Spoiler Shape and Setting Angle on Racing Cars Aerodynamic Performance

Abstract

Automotive racing is one of the favorite sports of human being. There have been many developments in past decades by car engineers to improve the performance of the engine and increase the aerodynamic efficiency of the race cars to achieve a better lap time and get a better placement safely. One of the ways to improve the aerodynamic performance of a race car is to use rear spoilers. This study by using ANSYS FLUENT numerically investigated the effect of the spoiler shape and setting angle on the aerodynamic characteristics of a race car and then it was validated by conducting wind tunnel experiment. Lift and drag coefficient of NACA0012, NACA4412, and S1223 are determined in Reynold’s number of 2×105 as an airfoil and as spoiler on ERC model which is a conceptual car model inspired by Porsche 911. It was found that ERC model with spoiler would have better aerodynamic efficiency compared to ERC model without spoiler. Also, S1223 at -6 degrees was identified as the optimized configuration as it generates the highest downforce. Even though the drag coefficient at this setting angle is slightly higher, but in terms of stability and handling IT is at its best. Overall, this study would help car manufacturers, for racing and commercial purposes, to have a better insight into the effect of spoiler configuration on the aerodynamic performance of cars. Hence, the stability, handling, and efficiency of the cars can be further improved by selecting the suitable spoiler configuration.

Finite-Time Control of Wing-Rock Motion for Delta Wing Aircraft Based on Whale-Optimization Algorithm

“…Based on our previous studies (Eftekhari & Al-Obaidi, 2019;Eftekhari et al, 2020;Al-Obaidi et al, 2021;Al-Qassar et al, 2021a;Al-Qassar et al, 2021b), in the current study, the main contribution can be highlighted by the following points:…”

Numerical Investigation of Hybrid Savonius-Darrieus Vertical Axis Wind Turbine at Low Wind Speeds

“…where 𝐹 𝐷 and 𝐹 𝐿 are drag and lift force respectively and A is the reference area, 𝜌 is the air density, V is the wind velocity and 𝐶 𝐷 and 𝐶 𝐿 are the drag coefficient and lift coefficient respectively [25]. Figures 14 and 15 respectively present the obtained result for the lift and drag coefficient for simulations and experiments for the three studied models on this research.…”

Active Disturbance Rejection Control of Wearable Lower-Limb System Based on Reduced ESO

“…Other techniques and methodologies can be pursued to extend this study for future work (Yung et al, 2016;Eftekhari & Al-Obaidi, 2019;Eftekhari et al, 2020;Kulshreshtha & Al-Obaidi, 2020;Al-Obaidi, 2021;Ali et al, 2020;Al-Obaidi, A. S. M. et al, 2021b;Eftekhari et al, 2023).…”