1996
DOI: 10.1002/(sici)1099-114x(199605)20:5<437::aid-er169>3.0.co;2-j
|Get access via publisher |Summarize |Cite
Study of the steady and transient temperature field and heat flow in the combustion chamber components of a medium speed diesel engine using finite element analyses
Search citation statements
Paper Sections
Select...
27
10
0
0
Citation Types
0
19
0
0
Year Published
1997
2022
Publication Types
Select...
23
9
2
Relationship
1
33
Authors
Journals
Cited by 34 publications
(19 citation statements)
References 0 publications
0
19
0
0
“…The methodology proposed, however, is affected by some uncertainties concerning the temperature swing measured on the surface of the aluminum piston. The resulting piston temperature, for example, is considerably higher than that found by several other authors through numerical simulations and experimental tests performed with thermocouples [7,8], consequently the reliability of the different experimental techniques is still unclear. In view of the above-mentioned limits, there is not nowadays any specific experimental technique that can provide sufficient details concerning combustion chamber coating thermal behavior during engine cycles.…”
Section: Introductionmentioning
confidence: 83%
“…The methodology proposed, however, is affected by some uncertainties concerning the temperature swing measured on the surface of the aluminum piston. The resulting piston temperature, for example, is considerably higher than that found by several other authors through numerical simulations and experimental tests performed with thermocouples [7,8], consequently the reliability of the different experimental techniques is still unclear. In view of the above-mentioned limits, there is not nowadays any specific experimental technique that can provide sufficient details concerning combustion chamber coating thermal behavior during engine cycles.…”
Section: Introductionmentioning
confidence: 83%
“…The wear surface was measured after the test at 200 N loading force, 5 Hz frequency and high temperature (100°C ± 5°C) for 2 h. Each experiment was repeated at least three times. The choice of lubricating oil temperature is based on the actual lubricating oil temperature range (Harigaya et al , 2002; Rakopoulos and Mavropoulos, 2015). The lubricating oil and specimens were intermittently heated for many times to strictly control their temperature change.…”
Section: Materials and Methodologymentioning
confidence: 99%
“…Then 2 g of stearic acid and 3 g of oleic acid were added to the mixed solution. Finally, oil-soluble nano powder was obtained after stirring for 4 h at 80 • C and drying by centrifugation [24]. The results of FTIR measurement of modified CeO 2 and graphene powder are shown in figure 3.…”
Section: Preparation and Modification Of Nanomaterialsmentioning
confidence: 99%
