Stress analysis of ribbon reinforced composites

Mother-of-pearl (nacre) is a platelet-reinforced composite, highly filled with calcium carbonate (aragonite). The Young modulus, determined from beams of a span-to-depth ratio of no less than 15 (a necessary precaution), is of the order of 70 GPa (dry) and 60 GPa (wet), much higher than previously recorded values. These values can be derived from ‘shear-lag’ models developed for platey composites, suggesting that nacre is a near-ideal material. The tensile strength of nacre is of the order of 170 MPa (dry) and 140 MPa (wet), values which are best modelled assuming that pull-out of the platelets is the main mode of failure. In three-point bending, depending on the span-to-depth ratio and degree of hydration, the work to fracture across the platelets varies from 350 to 1240 J m -2 . In general, the effect of water is to increase the ductility of nacre and increase the toughness almost tenfold by the associated introduction of plastic work. The pull-out model is sufficient to account for the toughness of dry nacre, but accounts for only a third of the toughness of wet nacre. The additional contribution probably comes from debonding within the thin layer of matrix material. Electron microscopy reveals that the ductility of wet nacre is caused by cohesive fracture along platelet lamellae at right angles to the main crack. The matrix appears to be well bonded to the lamellae, enabling the matrix to be stretched across the delamination cracks without breaking, thereby sustaining a force across a wider crack. Such a mechanism also explains why toughness is dependent on the span-to-depth ratio of the test piece. With this last observation as a possible exception, nacre does not employ any really novel mechanisms to achieve its mechanical properties. It is simply ‘well made’. The importance of nacre to the mollusc depends both on the material and the size of the shell. Catastrophic failure will be very likely in whole, undamaged shells which behave like unnotched beams at large span-to-depth ratios. This tendency is increased by the fact that predators act as ‘soft’ machines and store strain energy which can be fed into the material very quickly once the fracture stress has been reached. It may therefore be advantageous to have a shell made of an intrinsically less tough material which is better at stopping cracks (e. g. crossed lamellar). However, nacre may still be preferred for the short, thick shells of young molluscs, as these have a low span-to-depth ratio and can make better use of ductility mechanisms.

show abstract

scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.

Contact Info

hi@scite.ai

10624 S. Eastern Ave., Ste. A-614

Henderson, NV 89052, USA

Blog Terms and Conditions API Terms Privacy Policy Contact Cookie Preferences Do Not Sell or Share My Personal Information

Made with 💙 for researchers

Part of the Research Solutions Family.

Stress analysis of ribbon reinforced composites

Cited by 3 publications

References 9 publications

Permeability of glass ribbon-reinforced composites

Permeability of glass ribbon-reinforced composites

Polymer matrix, polymer ribbon-reinforced transparent composite materials

The mechanical design of nacre

Contact Info

Product

Resources

About