Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1
1

Citation Types

0
6
0

Year Published

2015
2015
2024
2024

Publication Types

Select...
3
3
2

Relationship

0
8

Authors

Journals

citations
Cited by 11 publications
(6 citation statements)
references
References 9 publications
0
6
0
Order By: Relevance
“…16,17 It has also been used to study the chip formation and the stress state in operando during cutting and the stress state of the chip during cutting. [18][19][20] In addition, high-energy x-ray scattering has been shown to be a useful tool for studying phase transformations and strains in hard coatings. 5,[21][22][23][24] We present here the first in operando results from an industrially relevant turning operation with a coated tool, recorded at the high-energy materials science beamline P07 at Petra III, using a two-dimensional detector and an x-ray energy of ∼80 keV.…”
Section: Articlementioning
confidence: 99%
See 1 more Smart Citation
“…16,17 It has also been used to study the chip formation and the stress state in operando during cutting and the stress state of the chip during cutting. [18][19][20] In addition, high-energy x-ray scattering has been shown to be a useful tool for studying phase transformations and strains in hard coatings. 5,[21][22][23][24] We present here the first in operando results from an industrially relevant turning operation with a coated tool, recorded at the high-energy materials science beamline P07 at Petra III, using a two-dimensional detector and an x-ray energy of ∼80 keV.…”
Section: Articlementioning
confidence: 99%
“…Brömmelhof et al found that the size of the grains decreased in the chip flow direction due to shearing. 19…”
Section: Articlementioning
confidence: 99%
“…In order to investigate the influences of the multiple parameters with various levels on the seismic behavior of the hybrid structural system, a series of quasi‐static test with uniform distribution of parameter levels was designed according to the orthogonal combination because of the advantages of less required number of test specimens. In this test, parameters of the section depth of columns (A), the length of masonry walls (B), and the grouting ratio of reinforced masonry (C) were accounted for the orthogonal analysis.…”
Section: Experimental Programmentioning
confidence: 99%
“…Thus, the understanding of the stress states on the chips during the turning process contributes to better design of a cutting process. Due to the difficulty of such experiments, only few studies on the chips generated at lower cutting speed have been carried out [159,163]. Here, the exact values of the strain in the chips could not be obtained due to the lack of the x-ray scattering information from its normal direction (ND) as shown in Figure 6.5 (a).…”
Section: Study Of the Chips Produced During A Turning Processmentioning
confidence: 99%