Output Power Maximization of Wind Energy Conversion System Using Doubly Fed Induction Generator

Deshpande, Nilesh; Kalange, Kundan; Lokhande, Smita

doi:10.1109/iicpe.2018.8709559

Cited by 4 publications

(4 citation statements)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…DC voltage for the inverter should be greater than peak value of the AC output voltage at least by 10%, and this is clearly accomplished in Figure 8 [21], [22]. Without using controller for the inverter stage, the voltage amplitude will be greater than the acceptable value for isolated power system.…”

Section: With Ordinary Pwm Controllermentioning

confidence: 99%

Control technique for power quality improvement of isolated wind power generation system

GÖREL

Fadhil

2023

Bulletin EEI

View full text Add to dashboard Cite

Power quality (PQ) problems for renewable energy system (RES) is major challenge for using these systems. Amplitude, frequency, and waveform is important PQ parameters especially for standalone or isolated systems. In this paper we propose RES with wind turbine (WT) and permanent magnet synchronous generator (PMSG) to feed different loads (liner, non-liner) through AC-DC-AC converter. The PMSG operate with fuzzy logic inertia controller, to convert turbine torque form PU to Nm. The inverter stage in the converter operate according to proportional integral derivative (PID) controller with 3rd harmonic injection pulse width modulation (PWM) to regulate the AC voltage in load side. For the same case study and operating condition, we compared the result for system parameters when using ordinary PWM and using PID with 3rd harmonic injection. Voltages total harmonics distortion (THD) was less than 2% with liner loads, and 3.5% with non-liner load and the same was for current load, the voltage amplitude was between (1-1.03) PU under different wind speed by using the proposed controller.

show abstract

Section: With Ordinary Pwm Controllermentioning

confidence: 99%

Control technique for power quality improvement of isolated wind power generation system

GÖREL

Fadhil

2023

Bulletin EEI

View full text Add to dashboard Cite

show abstract

“…The wind turbine generator control has been in the research focus in last two decades. The references (Abuaisha, 2014; Araghi et al, 2020; Bechir et al, 2012; Behnkel and Muljadi, 2005; Cardenas and Pena, 2004; Deshpande et al, 2018; Divya and Rao, 2006; Ekanayake et al, 2003; Inthamoussou et al, 2016; Jiao et al, 2005; Ledesma and Usaola, 2005; Mansouri et al, 2004; Martins et al, 2007; Mei et al, 2012; Mérida et al, 2014; Mihet-Popa et al, 2004; Rawn et al, 2006; Slootweg et al, 2003; Tapia et al, 2003, 2006; Trudnowski et al, 2004; Yin et al, 2016) analyze dynamic modeling of wind turbine generator and this issue can be classified in several topics: modeling presentation, modeling simplification, modeling comparison, and wind farm equivalent modeling. The model and dynamics of the wind turbine connected to an infinite power network is studied (Mansouri et al, 2004).…”

Section: Introductionmentioning

confidence: 99%

“…A WT generator modeling where rotational speed is the controlled variable is presented in Mihet-Popa et al (2004) including soft-starter start-up and power-factor compensation. Output power maximization of wind energy conversion system using doubly fed induction generator and applying Maximum Power Point Tracking (MPPT) algorithm, as well as its laboratory setup is presented in Deshpande et al (2018).…”

Section: Introductionmentioning

confidence: 99%

An efficient method for speed control of induction wind turbine generator with dual AC-DC-AC converter

Pesut

Ćirić

2021

Wind Engineering

View full text Add to dashboard Cite

One of the key issues in the efficient conversion of wind kinetic energy into electricity is the regulation of turbine speed to achieve maximum electrical power generation. The asynchronous generator with full load double AC-DC-AC power converter has not been widely used due to its poor performance in low wind speed. In this paper a method for turbine speed control of induction generator with full-scale double AC-DC-AC power converter to maximize absorbed wind power in the wide wind speed range, using the calculated maximum turbine power as a reference, is proposed. The configuration of an AC-DC-AC converter for connecting an asynchronous generator to the grid, as well as modeling of Pulse Width Modulation converter is presented in detail. Performance of the proposed control concept to maximize the absorbed wind power is verified through the simulation in MATLAB®. Finally, the advantages and disadvantages of the proposed control concept are discussed.

show abstract

“…However, there are not many papers working on how to improve the AEP of DFIGs. Most of them focus on the well-known maximum power point tracking (MPPT) algorithm [10]. Moreover, the control strategy for minimizing losses is studied in [11].…”

Section: Introductionmentioning

confidence: 99%

Improving Annual Energy Production of Doubly-Fed Induction Generators

Wang

Liu

Polinder

2021

IEEE Trans. Energy Convers.

View full text Add to dashboard Cite

Doubly fed induction generator (DFIG) based wind turbines are most employed for onshore applications because of their cost-effectiveness. The drivetrain improvement is barely studied due to the maturity of the DFIG based systems. This paper investigates two methods for improving the annual energy production (AEP) of the DFIG based wind turbines. They are referred to as short-circuited and -Y-connected DFIGs. The origins of the AEP improvement are elaborated from the drivetrain perspective. The improvement is quantified by the aerodynamic model of the turbine and the steady-state model of the DFIG. The two methods are then compared when applied to six regions with different wind speed distributions. The AEP improvements at six regions are evaluated and compared to derive the feasibility of the methods for different locations.

show abstract

Output Power Maximization of Wind Energy Conversion System Using Doubly Fed Induction Generator

Cited by 4 publications

References 3 publications

Control technique for power quality improvement of isolated wind power generation system

Control technique for power quality improvement of isolated wind power generation system

An efficient method for speed control of induction wind turbine generator with dual AC-DC-AC converter

Improving Annual Energy Production of Doubly-Fed Induction Generators

Contact Info

Product

Resources

About