Search citation statements

Order By: Relevance

Paper Sections

Select...
1
1
1
1

Citation Types

5
40
0
3

Year Published

2010
2010
2017
2017

Publication Types

Select...
7
1
1

Relationship

0
9

Authors

Journals

citations
Cited by 90 publications
(48 citation statements)
references
References 5 publications
5
40
0
3
Order By: Relevance
“…3, it can be seen that the higher the polymer loading, the better the elasticity of the wood specimens. Polymer-filled wood yielded higher MOE compared to raw wood because of the co-polymerization of the wood's cell wall, which was in accordance with other research (Hamdan et al 2010a, b;Yildiz et al 2005;Adams et al 1970). During impregnation, wood specimens coupled with monomers and filled the void spaces, which led to the increase in stiffness.…”
Section: Mechanical Propertiessupporting
confidence: 91%
“…3, it can be seen that the higher the polymer loading, the better the elasticity of the wood specimens. Polymer-filled wood yielded higher MOE compared to raw wood because of the co-polymerization of the wood's cell wall, which was in accordance with other research (Hamdan et al 2010a, b;Yildiz et al 2005;Adams et al 1970). During impregnation, wood specimens coupled with monomers and filled the void spaces, which led to the increase in stiffness.…”
Section: Mechanical Propertiessupporting
confidence: 91%
“…6). According to Yildiz's (Yildiz et al 2005) report, the MOR and MOE of solid wood (Populus, I-214) are 32.6MPa and 3.89 GPa, which are lower those of UHDFs, further, Li (Li et al 2017) had also reported that composite consisted of wood fiber and polypropylene also showed low mechanical properties. The MOR and MOE are 31.8 MPa and 2.52 GPa.…”
Section: Bending Strengthmentioning
confidence: 99%
“…www.intechopen.com The heat-catalyst-initiated method is now widely used by researchers (El-Awady 1999; Yildiz et al 2005;Li et al, 2009;2010a;2011a, 2011b and in industrial production, for it is less cost and easier operation; and the improvements in the physical and mechanical properties of wood species combined with anti-shrink efficiency make this method preferable to the -radiation method (El-Awady 1999). But, it also has some shortcomings such as longer reaction time over gamma radiation, sealed container requirement and releasing nitrogen during decomposition which normally results in void spaces in the resultant polymers within wood pores and thus decreases by the mechanical properties of wood-polymer composites.…”
Section: Polymerization Stylementioning
confidence: 99%
“…Due to resonance stability of allylic radicals, chain polymerization of allyl monomers does not take place efficiently and products obtained have very low molecular weight. Thus, these functional monomers are normally used with MMA, St and other monomers (Yildiz et al, 2005;Şolpan & Güven, 1999a). In addition, using methanol with MMA or St allows the polymer to penetrate the cell walls.…”
Section: Decay Resistancementioning
confidence: 99%