Investigation on flow field and heat transfer characteristics of film cooling with different swirling directions for coolant flow

Abstract

In this paper, a hexagonal prism inlet chamber is used to form a swirling flow for the film cooling, and three kinds of compound angle of film hole ( γ = 10°, 20°, 30°) with clockwise swirling or counterclockwise swirling are used for numerical simulation studies. The influence of different compound angles of film hole and the swirling directions for the film cooling effectiveness are obtained. The results show that the film cooling effectiveness and spanwise cooling coverage range of the clockwise swirling or counterclockwise swirling flow both are low when the compound angle of film hole is 10°. With the increasing compound angle of film hole, the kidney shaped vortex of film hole exit gradually weakens until it disappears, which reduces the entrainment effect by the coolant jet. So that the spanwise coverage range of two swirling modes is obviously improved. When the compound angle of film hole is 30° compared to 10°, the average spanwise film cooling effectiveness of clockwise swirling and counterclockwise swirling are increased by about 133.75 and 212.6%, respectively. The average spanwise film cooling effectiveness on the downstream of film hole for counterclockwise swirling is increased by about 140% compared with clockwise swirling.

Research on the flow field and film cooling effectiveness of the endwall with swirling film cooling

“…Finally, it is proposed that the shaped hole always had superior cooling effectiveness. Yang et al 3 and Zhang et al 4 conducted numerical studies on the effect of swirling coolant on film cooling performance on the turbine endwall. A similar conclusion is drawn that proper swirling flow could improve film cooling effectiveness.…”