Integrated Circuits for Medical Ultrasound Applications: Imaging and Beyond

Abstract

Medical ultrasound has become a crucial part of modern society and continues to play a vital role in the diagnosis and treatment of illnesses. Over the past decades, the development of medical ultrasound has seen extraordinary progress as a result of the tremendous research advances in microelectronics, transducer technology and signal processing algorithms. However, medical ultrasound still faces many challenges including powerefficient driving of transducers, low-noise recording of ultrasound echoes, effective beamforming in a non-linear, high-attenuation medium (human tissues) and reduced overall form factor. This paper provides a comprehensive review of the design of integrated circuits for medical ultrasound applications. The most important and ubiquitous modules in a medical ultrasound system are addressed, i) transducer driving circuit, ii) low-noise amplifier, iii) beamforming circuit and iv) analog-digital converter. Within each ultrasound module, some representative research highlights are described followed by a comparison of the state-of-the-art. This paper concludes with a discussion and recommendations for future research directions.

Exosomes and ultrasound: The future of theranostic applications

“…The applicability of ultrasound was recognized and brought into light in 1950s and this started with John William Strutt (Lord Rayleigh), who clearly described the theory of ultrasound and its applicability in various field [ [264] , [265] , [266] ]. Diagnosis of mitral stenosis by echocardiogram and abdominal imaging with pulsed ultrasound has revolutionized the medical imaging [ 9 ].…”

Design of a CMOS Analog Front-End for Wearable A-Mode Ultrasound Hand Gesture Recognition

“…On the TX branch, the TX beamformer circuit is responsible for the desired transmitted ultrasound beam pattern by generating the delay pattern and complex weights [12]. The TX beamformer controls the pulser, which amplifies the TX beamformer signals into several tens of Volt.…”

Bottom-up micromachined PZT film-based ultrasonic microphone with compressible parylene tube

“…When alternating and bias voltages are applied between the two electrodes, the induced electrostatic force causes membrane vibration, producing ultrasound [12]. However, CMUTs generally require high DC bias and complex front-end circuits [13]. The PMUT comprises a deformable piezoelectric membrane interposed between the upper and lower electrodes.…”