Influence of edge effects on single event upset susceptibility of SOI SRAMs

Gu, Shuhang; Liu, Jie; Zhao, Fei; Zhang, Zhangang; Bi, Jinshun; Geng, Chao; Hou, Ming; Liu, Gang; Liu, Tianqi; Xi, Kai

doi:10.1016/j.nimb.2014.10.018

Cited by 5 publications

(1 citation statement)

References 27 publications

(29 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Some literatures also explain the effect of heavy ion parameters on irradiation effects. Reference [7] analyzed the influence of heavy ion incidence angle on SEU cross sections of the SRAM. Reference [8] compared the effects of different LETs and heavy ion incident positions on the SEU of a 22 nm Fully Depleted Silicon-On-Insulator (FDSOI) SRAM, and considered that whether SEU occurs depends on the peak value of transient current generated after heavy ion incidence.…”

Section: Introductionmentioning

confidence: 99%

Research on heavy ion irradiation effects on SOI SRAM

Li,

Hao,

Zhao

et al. 2023

J. Inst.

View full text Add to dashboard Cite

SRAM based on SOI devices has been widely used in aerospace storage devices due to its good electrical characteristics and radiation resistance. However, with the development of semiconductor technology, the feature size of devices continues to shrink, and the irradiation effects of high-energy ions have become increasingly serious. Single event effect has become the biggest threat to the failure of the spacecraft. A mixed-simulation method was used to research the heavy ion irradiation effects on SOI SRAM. SRAM consists of two coupled inverters. Firstly, the voltage changes of the inverter and SRAM output nodes under heavy ion irradiation were compared and analyzed, then the influence of the device itself and heavy ion parameters on the single particle flipping effect of the SRAM is investigated, and finally the necessary conditions for the flipping of the stored information in the SRAM are discussed and derived. The results show that heavy ion incidence does not permanently change the final state of the inverter; devices in the off state in the SRAM will undergo information flipping only when they are irradiated by heavy ions, and the threshold voltage of the N-type MOSFET is lower than that of the P-type MOSFET; an increase in the penetration depth will accelerate the flipping speed of the SRAM, but when the LET is high, the influence of the penetration depth on the flipping speed decreases; the change of the stored information in the SRAM is the result of the combined effect of pulse width and pulse height.

show abstract

Section: Introductionmentioning

confidence: 99%