High-Thermoelectric Performance of Nanostructured Bismuth Antimony Telluride Bulk Alloys

Abstract

The dimensionless thermoelectric figure of merit (ZT) in bismuth antimony telluride (BiSbTe) bulk alloys has remained around 1 for more than 50 years. We show that a peak ZT of 1.4 at 100 degrees C can be achieved in a p-type nanocrystalline BiSbTe bulk alloy. These nanocrystalline bulk materials were made by hot pressing nanopowders that were ball-milled from crystalline ingots under inert conditions. Electrical transport measurements, coupled with microstructure studies and modeling, show that the ZT improvement is the result of low thermal conductivity caused by the increased phonon scattering by grain boundaries and defects. More importantly, ZT is about 1.2 at room temperature and 0.8 at 250 degrees C, which makes these materials useful for cooling and power generation. Cooling devices that use these materials have produced high-temperature differences of 86 degrees , 106 degrees , and 119 degrees C with hot-side temperatures set at 50 degrees, 100 degrees, and 150 degrees C, respectively. This discovery sets the stage for use of a new nanocomposite approach in developing high-performance low-cost bulk thermoelectric materials.

Low Sound Velocity Contributing to the High Thermoelectric Performance of Ag8SnSe6

“…One successful strategy for improving zT is to enhance the power factor S 2 / ρ through band engineering,2, 3, 4, 5, 6, 7 provided the carrier concentration is optimized 8. The other effective strategy is typified by minimizing the only one independent material property, the lattice thermal conductivity ( κ L ), through nanostructuring,9, 10, 11, 12, 13, 14, 15 liquid phonons,16, 17 and lattice anharmonicity 18, 19…”

New Insights into Intrinsic Point Defects in V2VI3 Thermoelectric Materials

“…To this end, no TE material would have achieved its best performance without defects 9. The canonical “phonon‐glass electron‐crystal” strategy is implemented via concertedly engineering point defects, textures, grain boundaries, and nanoinclusions to reduce the κ ph 10, 11, 12, 13, 14, 15, 16, 17 and enhance the PF 18, 19, 20, 21, 22, 23, 24, 25…”

Heavy Doping by Bromine to Improve the Thermoelectric Properties of n‐type Polycrystalline SnSe

“…Numerous approaches have been explored to enhance TE performance, including increased power factor ( S 2 σ) by band engineering (resonant doping, band convergence, and band flattening , etc. )3, 4, 5 and decreased thermal conductivity by defect engineering,6 and nanoengineering 7, 8, 9. An alternative way to achieve high ZT values is to seek new classes of TE materials with intrinsically low thermal conductivity, such as clathrates, skutterudites, sulfur‐based compounds, Ag 9 GaSe 6 , and SnSe etc 10, 11, 12, 13, 14…”