1997
DOI: 10.1002/(sici)1099-1018(199703)21:2<67::aid-fam596>3.0.co;2-n
|Get access via publisher |Summarize |Cite
Fire-resistant Aluminosilicate Composites
Search citation statements
Paper Sections
Select...
271
49
4
1
Citation Types
0
112
0
2
Year Published
1999
2026
Publication Types
Select...
259
31
25
1
Relationship
0
316
Authors
Journals
Cited by 316 publications
(114 citation statements)
References 6 publications
0
112
0
2
“…The pHRR will be weighted on the time at which the maximum heat release rate is recorded, while the THR will be weighted on the time at which the flaming phenomenon starts, which directly affects the area under the HRR curve. Thus, the FSI and FPI measures already defined by Lyon and coworkers [4] would , Figure 4c) even at a very low loading percentage., e.g., by combining LDH with graphene in EP. Based on the statistics used in this survey, the use of FRI (t i ), FRI (t p ), or FRI (t i &t p ) does not change the category of flame retardancy performance.…”
Section: Visualizationmentioning
confidence: 60%
“…The pHRR will be weighted on the time at which the maximum heat release rate is recorded, while the THR will be weighted on the time at which the flaming phenomenon starts, which directly affects the area under the HRR curve. Thus, the FSI and FPI measures already defined by Lyon and coworkers [4] would , Figure 4c) even at a very low loading percentage., e.g., by combining LDH with graphene in EP. Based on the statistics used in this survey, the use of FRI (t i ), FRI (t p ), or FRI (t i &t p ) does not change the category of flame retardancy performance.…”
Section: Visualizationmentioning
confidence: 60%
“…To better elucidate the fire behavior of the epoxy samples, time to flashover (TTF) and flame propagation index (FPI) were calculated (Table ). , The first parameter represents the time available to escape a fire in a confined space − (see Section S4), while the second one depends on the flammability (i.e., front flame movement). E12AP_12HAURAPP and E6AP_6HAURAPP samples showed significantly increased TTF and, therefore, were characterized by lower FPI, smoke production rate (SPR), and total smoke release (TSR) with respect to the pristine resin (Table and Figure S6).…”
Section: Results
and Discussionmentioning
confidence: 99%
“…The remaining water evaporated at a temperature higher than 250 °C according to the following dehydration reaction [ 35 ]: 2(SiO 3 2− ·2M + ) –OH → (SiO 3 2− ·2M + ) 2 ·O + H 2 O (↑) …”
Section: Resultsmentioning
confidence: 99%
