Extraordinary long-term cycleability of TiO₂-B nanorods as anodes in full-cell assembly with electrospun PVdF-HFP membranes

A High-Performance Rechargeable Mg2+/Li+ Hybrid Battery Using One-Dimensional Mesoporous TiO2(B) Nanoflakes as the Cathode

“…For the TiO2(B)|Li cells, the B peak is likely due to Li + insertion-deinsertion. 31 It should be noted that this peak sometimes was ascribed to the Li + ions interacting with minor anatase TiO2, 37 which was not observed in our XRD and Raman analysis (Figure 1a and 1b). The S2 and S1 peaks are related to the characteristic pseudocapacitive behavior on the surface.…”

Overlithiated Li 1+x Ni 0.5 Mn 1.5 O 4 in all one dimensional architecture with conversion type α-Fe 2 O 3 : A new approach to eliminate irreversible capacity loss

“…Structural and morphological features of all 1D structured components like LiNi 0.5 Mn 1.5 O 4 , a-Fe 2 O 3 and PVdF-HFP membrane have been studied extensively with improved electrochemical activity and reported in previous works [22][23][24]27,28,30]. Therefore, we followed the same synthetic procedures to prepare all the active materials for the present work.…”

“…X-ray diffraction (Bruker AXS, D8), field emission scanning electron microscope (FE-SEM, JEOL JSM-7600F) and transmission electron microscopic (TEM, JEOL 2100F) studies were performed for all the nanofibers and given in our previous work [9,24,29,30]. Ionic conductivity of electrospun PVdF-HFP membranes was studied using two stainless steel (SS) blocking electrodes (SS| electrospun PVdF-HFP membrane|SS).…”

Ionic‐Liquid‐Assisted Synthesis of Self‐Assembled TiO2‐B Nanosheets under Microwave Irradiation and Their Enhanced Lithium Storage Properties

“…The ratio of TiO 2 -B to anatase was determined to be 85 %, based on the calculation method proposed by Beuvier et al [26] The crystal phase of IL-180-10 was further evidenced by Raman spectroscopy (see Figure S2 in the Supporting Information), which agrees well with previous reports on TiO 2 -B nanostructures. [26][27][28][29] Nitrogen adsorption and desorption isotherms were measured to determine the Barrett-Emmett-Teller (BET) surface area and the porosity of the products. Figure 2 shows typical type 4 behavior with a clear loop, which indicates that IL-180-10 has a mesoporous nature.…”