Etched fiber Bragg grating probe using a regular CNC machine and a 3D printer

Abstract

Etched fiber Bragg gratings (EFBGs) have been widely employed for refractive index (RI) measurements that can be used to monitor sugar consumption during the fermentation of alcoholic beverages. EFBGs are obtained by removing the cladding of a fiber Bragg grating, which is traditionally performed by a chemical attack with hydrogen fluoride, an extremely hazardous corrosive substance that causes severe wounds and even death. To overcome such drawbacks, this technical note presents a simple, practical, and low cost method for the diameter reduction of single mode optical fibers by mechanical polishing, employing a small scale computer numerical control device and an ad hoc 3D-printed rod. The sensor probe obtained was tested using sucrose aqueous solutions with RIs between 1.333 and 1.394, measured in an Abbe refractometer. The results show a linear shift of the Bragg wavelength with respect to RI with a correlation of 0.928.