Energy and Cost Analysis of a New Packed Bed Pumped Thermal Electricity Storage Unit

Abstract

Renewable energy sources (RES) are quite capable to actively contribute to meet the today's energy demand. However, many of them have a time-dependent nature that constitutes their major disadvantage. To overcome this drawback, energy storage systems (ESS) need to be set up. In this way, the stored energy can be used in the absence of RES or under peak demand hours. High-temperature pumped thermal electricity storage (PTES) using packed bed constitutes an attractive solution but is characterized by high losses and irreversibilities. For this reason, in this paper, a new plant scheme is presented and its mathematical model built up. To predict the packed bed behavior, a one-dimensional two phase model of the hot and cold storages has been included, while the plant feasibility is evaluated using an energy and a cost analysis. Results show that the highest quantity of energy and round-trip efficiency are reached with a packed bed made of magnetite and titanium oxide.

Regulated Emissions of Biogas Engines—On Site Experimental Measurements and Damage Assessment on Human Health

“…Drawback that can provoke mismatch between power supply and demand which in turns can result in management and control problems, devices fault or, even worse, from local to global blackout. Obviously, these issues can be easily solved developing and installing large-scale energy storage plants (see, e.g., References [8][9][10][11][12][13][14][15][16]) and managing properly fossil fuels power units in order to avoid components life-time reduction (see, e.g., References [17][18][19][20][21][22][23]). Independently to these facts, wind and solar can not guarantee a both stable and programmable production as well as a simultaneous generation of electricity and heat/cold: strengths of plants working with bioenergy as input.…”

Life Cycle Assessment of a Commercially Available Organic Rankine Cycle Unit Coupled with a Biomass Boiler

“…However, being electricity demand instantaneously balanced 24/7, huge and unpredictable power changes can be the source of imbalances between supply and demand that can provoke grid damage, user devices fault or blackouts. These unpleasant effects can be managed and/or limited using fossil fuels power plants working in cycling operation mode and energy storage units (see e.g., [7][8][9][10][11][12][13][14][15][16][17]).…”

An Experimental Investigation of a Novel Low-Cost Photovoltaic Panel Active Cooling System

“…Therefore, as stated in several research works (see, e.g., [10][11][12][13][14][15][16]), to prevent such damaging situations, fossil fuel power stations need to be used as back-up units, and electricity energy storage systems need to be installed.…”